Correct Replacement Circuit Board for a MaxxFan Deluxe 8501 Roof Vent

Question

Question:

Maxxfan 8501k circuit board replacement you have one listed for the 8500, is this also the one for 8501 model?

asked by: Craig K

0

Expert Reply:

Yes, the Replacement Printed Circuit Board for MaxxAir Powered Lift RV Roof Vents w/ Exhaust Only Fan # MA39FR is the correct replacement circuit board for your 8501 model.

expert reply by: Bryce D

0

Answer 1

Since multiple MaxxAir Fans have the same features that you listed it's honestly best to first determine the exact model number you have before purchasing anything and end up not having it be compatible. I've listed below all the available…

view full answer...

Answer 2

The 10B21275KE part #MA39FR replaces the 10-21275KE you mentioned as well so if you had an older model number you could use it in same application.

view full answer...

Answer 3

The 10C21275KEZ didn't come back to anything for me which means it's most likely already been replaced with a new version but I can't confirm which with just the part number. We typically just replace the circuit boards based on the model…

view full answer...

Answer 4

I did some checking and for the MaxxAir the correct replacement circuit board is the #MA39FR.

view full answer...

Answer 5

The correct Replacement Operator Mechanism for your model 4751KS MaxxAir MaxxFan is part #MA10-20281K-1AF. If your fan lid is unable to open even manually, then this is the part you need to replace. The other part you referenced, #MA10A04751KS would…

view full answer...

Answer 6

Since you have the exhaust only model the correct replacement circuit board is the Replacement Printed Circuit Board for MaxxAir Powered Lift RV Roof Vents w/ Exhaust Only Fan #MA39FR.

view full answer...

Answer 7

The two most likely causes of a MaxxAir vent fan lid not opening or closing are either going to be a lift motor or operator failure. I recommend removing the motor and applying power directly to this to see if the shaft turns. If not, you know the…

view full answer...

Answer 8

If you have 12 volts going to the fan it is motor. You will need the Replacement 12-Volt Variable Speed Fan Motor for MaxxAir MaxxFan RV Roof Vents item #MA10-20968. If the voltage isn't going to the motor than it could be the controller which is…

view full answer...

Answer 9

I can't find any info on the part number you mentioned but could I maybe see a picture of the and/or know what specific fan you have installed?

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Correct Replacement Circuit Board for a MaxxFan Deluxe 8501 Roof Vent

Product Page this Question was Asked From

Continue Researching