How To Wire The Transfer Switch When Installing The Go Power Weekender RV Solar System
Updated 04/25/2022 | Published 04/24/2022 >
Question:
So I wired transfer switch like it said to do . But now my generator won’t charge battery because the charger go through the inverter transfer switch. So can I just wire a separate wire from generator to charger/converter??
asked by: Benjamin D
Expert Reply:
When installing the transfer switch # 342GPTS for your Go Power Weekender ISW RV Solar Charging System # 34282183 the generator/shore power should be wired to the N.O. Neutral and N.O. Hot terminals along with the converter charger.
The Inverter should be wired to the N.C. Neutral and N.C. Hot terminals. If you have the inverter on the same terminals as the shore power/generator then it will never kick back and forth between the two. The inverter can not be wired to the same terminals as the charger as this will just create a loop of the battery running the inverter to charge itself and will quickly drain your battery.
When the generator is running it's going to send power to the N.O. terminals, which also have the charger wired to them, thus sending power to the charger as well.
Product Page this Question was Asked From
Go Power Automatic Transfer Switch with Quick Connect Cables - Plastic Case - 30 Amp - 120V
- RV Transfer Switch
- 30 Amp
- 120V
- Shore Power to Inverter
- Go Power
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Tire Chains
- Shop: Go Power Automatic Transfer Switch - Plastic Case - 30 Amp - 120V
- Shop: Titan Chain Snow Tire Chains w/ Cams for Dual Tires - Ladder Pattern - Twist Link - 1 Axle Set
- Search Results: 30 amp transfer switch
- Shop: Suspension Enhancement
- Q&A: Why is Transfer Switch Needed with RV that Uses Shore Power and Generator
- Video: Review of the Replacement Wet Shoulder Bolt
- Shop: Go Power Automatic Transfer Switch with Quick Connect Cables - Plastic Case - 30 Amp - 120V
- Shop: Go Power Automatic Transfer Switch - Metal Case - 50 Amp - 120V/240V
- Q&A: Does the MORryde Replacement Wet Shoulder Bolt Come W/ a Nut
- Video: Review of MORryde Trailer Suspension Parts - MR85DR
- Shop: Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Search Results: trailer hitch
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Search Results: trailer tires and wheels
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Shop: Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons
- Article: How to Measure for Trailer Hitch Drop
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Search Results: trailer wiring
- Shop: Brake Controller
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Search Results: trailer jack
- Video: Choosing the Right Vehicle Suspension Upgrades




