RV HVAC Register for 5 inch Diameter Duct Opening

Question

Question:

Item # A10-3359VP Looks like it needs to go in a hole that is 5 3/4 dia. My current vent cover hole is about 5”. It will not close and looking for cover that will close. Do you have one that fits in my hole? Thanks

asked by: Chris Z

0

Expert Reply:

Valterra offers a register that's designed to fit a 5 inch duct opening. You'll want to use part # A10-3360VP.

expert reply by: Mike L

0

Answer 1

It sounds to me like the cutout hole is a bit too tight and is pinching the base in, not allowing the inner ring with the shutters to spin. If you're saying that you're testing it before even placing it in the cutout hole and can't get it…

view full answer...

Answer 2

There are four clips that hold the outer vent portion of the Valterra Adjustable A/C Ceiling Register #A10-3359VP to the collar that attaches with screws. To remove the outer section once installed you'd need to reach your finder into the vent…

view full answer...

Answer 3

The Valterra RV Vent Ceiling Register #A10-3359VP that you mention, actually has a 5-3/4" opening. The 5" listed is referring to the grille opening, whereas the actual mounting dimension is 5-1/8". If you're needing a ceiling…

view full answer...

Answer 4

Hey Timothy! We can definitely get you the parts you need to flat tow your 2022 Grand Wagoneer. For a Blue Ox setup I recommend the following: -Blue Ox Base Plate Kit #BLU66XR (If you DO NOT have tow hooks) -Blue Ox Base Plate Kit #BLU46CR (If you DO…

view full answer...

Answer 5

Hey Craig! Is this a Lippert Ground Control system? Is the part actually 304136? I asked Lippert and they said they don't have anything under 304135. If it is the 304136 the correct replacement is the Replacement Control Module for Lippert Ground…

view full answer...

Answer 6

The light beige Valterra Adjustable A/C Ceiling Register part #A10-3360VP has more of a pale brown tone to it then the Valterra Adjustable A/C Ceiling Register medium white part #A10-3359VP. If you would like more of a light brown color, I recommend…

view full answer...

Answer 7

Hello Jacob, thanks for reaching out. Installing the B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit #BWGNRK1020 should take about 2 hours for an experienced installer. Maybe more like 3-4 hours for first-timers. This…

view full answer...

Answer 8

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 11

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

RV HVAC Register for 5 inch Diameter Duct Opening

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching