Replacement Lens for an Optronics 20327-02 Light Base

Question

Question:

I need to replace a red running light lense I have a 2021 FR Evo. Can you help me identify which part number I need to order from you?

asked by: Dave A

0

Expert Reply:

The "20327-02" light base is a rectangular shaped clearance light measuring 4" long x 2" wide which was made by Optronics. The light has since been discontinued along with the replacement lens but we have had customers successfully use the Replacement Red Lens for Optronics # A32RB as a replacement.

expert reply by: Scott S

0

Optronics 20327-02 Light Base
(click to enlarge)

Answer 1

The "20327-02" light base is a rectangular shaped clearance light measuring 4" long x 2" wide which was made by Optronics. The light has since been discontinued along with the replacement lens but we have had customers use part…

view full answer...

Answer 2

Thank you for providing the part number from your trailer's marker light. Unfortunately I could find out only that this was evidently an Optronics product and I believe it is a rectangular light. Their website offers no results for that item so…

view full answer...

Answer 3

Hi James/Debra; I'm sorry to say the Valterra RV Ceiling Vent w/ Rotating Grille - 5" Diameter is only available in white #A10-3363VP or the beige #A10-3362VP you already found. Valterra does not offer the 5" in black.

view full answer...

Answer 4

What you described is a classic insufficient trailer ground. What you will need to do is run a jumper wire from the ground wire on the trailer connector (7:00 pin on the 7-way) to the trailer frame and the intermittent issue will go away. What is…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Hey Roy, welcome back! The mounting hardware available for the Batwing Awnings attaches to crossbars or platform racks. I don't have a way to attach a Batwing awning directly to the side or top of your Popup camper and Rhino-Rack doesn't…

view full answer...

Replacement Lens for an Optronics 20327-02 Light Base

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching