Does Install of SumoSprings Kit Require Front End Alignment

Question

Question:

After installing sumosprig do I have to do alignment

asked by: Boguslaw

0

Expert Reply:

The install of a SumoSprings Kit like the part # SSF-106-47 does not require getting an alignment on the vehicle.

expert reply by: Jameson C

0

Answer 1

You are definitely on the right track with the SumoSprings. For your 2021 Toyota Tacoma, I recommend using the SumoSprings Solo Custom Helper Springs - Rear Axle #SSR-612-47. The reason why is because this model of SumoSprings will provide your…

view full answer...

Answer 2

Let me begin by saying that trailer tires have a speed rating that can be as low as 65 mph. Check the sidewalls of your tires for the speed rating. Consistently exceeding the speed rating of the tire can shorten its life expectancy. Having tires that…

view full answer...

Answer 3

That is definitely odd, but I would lean towards a hub/bearing issue. I didn't see you mention this step, but when installing the new hubs/bearings did you tighten the castle nut nice and tight to seat the bearings fully, and then loosen it up to…

view full answer...

Answer 4

There isn't a leaf spring helper system that is able to be used on your 2022 Ford E-450 combined with the SumoSprings Maxim Custom Helper Springs #SSR-106-47-1. Reason why is these mount on top of the leaf spring pack so a leaf spring helper like…

view full answer...

Answer 5

For the rear axle of your 2019 Fourwind that's built on a Ford E-450 chassis the SumoSprings part #SSR-130-54 would be a great option that's confirmed to fit. Then for the front axle you'd want the part #SSF-106-47 and you'd be set.

view full answer...

Answer 6

I looked up pictures of your 2018 Coachman Leprechaun 311 FS and it looks to have a black RV ladder very similar to our Stromberg part #LA-401BA which is 99-1/2 inches tall and can be trimmed down shorter if needed. I attached a picture we got from a…

view full answer...

Answer 7

We do not have a direct replacement ladder with that part number however, we do have the Stromberg Carlson RV Exterior Ladder w/ Hinges, #LA-401BA in black finish or #LA-401 in aluminum.

view full answer...

Answer 8

We do have an option for suspension enhancement for your motorhome on a 2020 Chevy Express 4500 cutaway chassis, but the SuperSprings SSA245-2 won't fit since you do not have the top overload spring, as they are designed to install on top of the…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...