How much of the Ventline Vanair Trailer Roof Vent Will Stick Inside of the Trailer
Updated 08/06/2013 | Published 08/03/2013
Question:
What is the minimum thickness without adding a spacer.
asked by: Nick
1
Helpful Expert Reply:
If you remove the garnish that comes with the vent # VP-543SP and measure from the bottom of the base that mounts to the top of the roof down it is 1-3/8 inches to the bottom of the main housing and 3-3/4 inches to the bottom of the handle (with the vent closed). I made a video that shows where these measurements are being made.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Ventline Vanair Trailer Roof Vent w/ 12V Fan - 6-1/4" Diameter - Smoke
- RV Vents and Fans
- Vent
- Roof Vent
- Manual Lift
- 12V Fan
- Plastic
- Tinted
- Ventline
more information >
Continue Researching
- Shop: Ventline Vanair Trailer Roof Vent w/ 12V Fan - 6-1/4" Diameter - Smoke
- Q&A: Can the Ventline Vanair Trailer Roof Vent Install on Thinner Roofs
- Q&A: How Tall is the Exterior Portion of the Ventline Vanair 12-Volt Trailer Roof Vent # VP-543SP
- Q&A: Replacement Outside Cover for a Ventline as-13 m-va 204 Vent
- Q&A: Recommended Replacement For A Ventline AS-13M RV Roof Vent
- Q&A: Replacement Motor and Diagram for Ventline Vanair Trailer Roof Vent
- Q&A: Replacement Legs for Lippert Components Ground Control 3.0 Electric Leveling System
- Q&A: Rear Suspension and Sway Bar Recommendation for 2020 Pleasureway Lexor
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: REDARC Tow-Pro Liberty vs Tow-Pro Elite
- Article: Trailer Wiring Diagrams
- Article: 4-Step Guide to Installing RV Solar Power
- Article: How Much Solar Power Do I Need For My RV?
- Article: RV Propane 101: How Does My RV's Propane System Work?