Replacement Motor for Lippert Electric Leveling Jack on a 2007 Fleetwood Bounder Motorhome

Question

Question:

2007 Fleetwood bounder 34f motorhome, 22,000 GVW 8.1L 5B4MP67G363419444 Neet to replace the right rear Lippert leveling jack motor passenger side

asked by: Steven C

0

Expert Reply:

Thanks for all the information. You will want to grab the Replacement Motor for Lippert Power Gear Electric Leveling Jack System item # LC89CJ. This will replace the passenger side motor for your Lippert Leveling Jack.

expert reply by: Jerred H

0

Answer 1

Your 2008 Fleetwood Bounder has a power gear electric leveling system. That unfortunately was not a great system and was discontinued. I don't have any replacement parts for that system but it sounds like the controller/brain of the system is…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 4

Hey Dean, the Detail K2 Elite Snowplow part #K2AVAL8219ELT that you referenced comes with all of the electrical components it will need to install. It wires to the vehicle battery as well as comes with a wired switch that you would run to the cab of…

view full answer...

Answer 5

Hey Victor, yes the Long U-Bolt Kit part #RM33KT is a Roadmaster brand u-bolt kit. This does include nuts and washers as well.

view full answer...

Answer 6

I really wish we could help but we don't have anything for a 9 inch square pad. EDIT: Since we know you have 8 inch feet you can use the part #SN37FR.

view full answer...

Answer 7

While I was unable to confirm the exact dimensions of the Norcold 1200LRIM, I think your current refrigerator to be 63-1/4 inches tall, 32-11/16 inches wide, and 24 inches deep. Please confirm this. The Everchill RV refrigerator with freezer drawer…

view full answer...

Answer 8

For 1/2 inch trailer u-bolts that attach to axle the recommended torque value is between 45 and 70 ft lbs of torque.

view full answer...

Answer 9

Since you don't have the wiring harness on your previous RV water heater you most likely had an all propane powered unit. The Atwood RV Water Heater w/ Heat Exchange - Gas and Electric - Automatic Pilot - 8,800 Btu - 6 Gal #AT96163 is powered by…

view full answer...

Answer 10

There are many variables when installing the Double-Panel On/Off Switch for Dometic Gas / Electric Combination Water Heaters part #AT91230 therefore it is best to match the wire to the terminals using its function, not the color. The reason for this…

view full answer...

Answer 11

Hey Carolyn, the XD versions of the Sprinter 3500 chassis are the dually versions so you would need to make sure the sway bar you have is compatible with dually models. For example the Hellwig #HE77YR is a bar that does work with the dually models…

view full answer...

Answer 12

You're already on the right track with everything you looked at. Your 2018 Thor ACE 30.3 has a GVWR of 18,000 lbs so I recommend the following: -Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets for Class A Motorhomes #RM33RR…

view full answer...

Replacement Motor for Lippert Electric Leveling Jack on a 2007 Fleetwood Bounder Motorhome

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching