Rivet Size to Use with Replacement Black UWS Logo Badge # UWS99FR

Question

Question:

What size are the rivets supposed to be

asked by: Jody A

0

Expert Reply:

The holes of the Replacement Black UWS Logo Badge # UWS99FR are 3/16 inch so going with rivets that diameter or slightly smaller would work well.

expert reply by: Jameson C

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 5

Hey Brian. The Curt Trailer Connector Adapter item #C57672 is going to install in the same way on your 2023 F-150 as it did on the video we made for a 2021 F-150. Those trucks are the same generation but I can not guarantee the wiring colors are…

view full answer...

Answer 6

Hey Kurt, yes you can use the Blue Ox anti-rattle device part #BX88224 with your Curt weight distribution system. It will do a great job preventing movement and noise. What are you towing?

view full answer...

Answer 7

Hello Dan, Great question. When you’re comparing the Firestone kits #F59VV and #F2582, they both technically fit your 2025 F-150, but they are designed around different mounting locations and truck configurations. The #F2582 is the traditional…

view full answer...

Answer 8

Unfortunately you can not Doug. The factory hitch on your 2020 Ford F-150 Lariat is part of the rear step-bumper assembly. It's bolted to your frame and then the step-bumper bolts to the trailer hitch. Removing the factory hitch removes the…

view full answer...

Answer 9

Hey Gregory, that's really good information. You’ve got a few options, but I wouldn’t jump straight to replacing the leaf springs on a half-ton for that size trailer. Since you’re using a Curt weight distribution hitch, that should be doing most…

view full answer...

Answer 10

Hi Jeff, The K-Source Snap & Zap Custom Towing Mirrors part #KS69NQ will work with your Lariat mirrors while allowing you to retain the use of the camera and side lights! These mirrors are specifically designed to match the contours of the side…

view full answer...

Answer 11

Hey Eric, the Weigh Safe True Tow part #WS37RR that you referenced would be your best option for a weight distribution system for your Grand Design 25G. What are you towing the Grand Design with and does it have a 2.5 inch hitch?

view full answer...

Answer 12

Hey Richard, yes you can set the tension in the springs of the RoadActive Suspension Kit part #RAS3611-Y low enough so that the suspension height is not raised at all. If you add in a lot more tension it will slightly affect the ride height like you…

view full answer...

Rivet Size to Use with Replacement Black UWS Logo Badge # UWS99FR

Continue Researching