Upgrade Kit for Kwikee Series 42 RV Step Made before 1999

Question

Question:

Hi, I have a pre 99 series step in a 1999 Country Coach Allure I would like to upgrade the motor/gearbox to the new LC369473. Also need the newest style controller. This is the one that plugs directly into motor. Can you confirm if it needs a different door switch NO I need the round countersunk style. Thanks,

asked by: Mike W

0

Expert Reply:

Since you have a pre-1999 Kwikee Series 42 RV step the correct upgrade kit you'd need is the part # LC380266 which comes with the type of motor you are wanting as well as all of the electronics needed as well.

expert reply by: Jameson C

0

Answer 1

Currently Lippert only offers the Replacement Motor with Box Brackets #LC369473 for your Kwikee 42 Series Steps #LC372779. In the event your steps were made in 1999 or earlier you will need to use the Motor Upgrade Kit #LC380266 to have the updated…

view full answer...

Answer 2

Sounds like you are looking for the replacement table for your Kwikee Series 42 steps which would be part #LC372749 as well as the slides #LC369690 and you'd be set.

view full answer...

Answer 3

I reached out to the manufacturer, who told me the correct part for the conversion kit is the Lippert Components Kwikee Step KIT CONV 42 SER 9510 CNTRL MOTOR (909777000) #LC380266.

view full answer...

Answer 4

Hey Ray, thanks for the photo and explanation! Lippert has a variety of replacement parts that look like they might work, but when I reached out to my contact to verify what would be the correct piece they said you have an older system and the parts…

view full answer...

Answer 5

If you do indeed have the Series 42 Kwikee Steps then the correct replacement motor/gear for you is the Lippert Components Kwikee Step Motor Assembly part #LC369473. We also offer the motor separately as part #LC369506 (same as Series 25) and the…

view full answer...

Answer 6

Sounds like you are looking for the Replacement Self-Lubricating Bushing for Lippert Electric Coach Step #LC116531 which does not come with the gear part #LC369354 that you referenced.

view full answer...

Answer 7

I tried looking up your invoice using the email you provided but was unable to find an invoice with any RV steps, that being said if you have the Kwikee 47 Series steps #LC427247 that you were looking at then I have attached the wiring diagram for…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Upgrade Kit for Kwikee Series 42 RV Step Made before 1999

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching