Replacement 30 Amp Converter For Travel Trailer

Question

Question:

I have a Dutchmans Adirondack 30RL and I need to replace the 30 amp converter.

asked by: David M

0

Expert Reply:

While we have no way of knowing what converter is in a Dutchmen Adirondack trailer, you can use the following:

- Progressive Dynamics 9300 Series RV Converter Charger # PD49RR

expert reply by: Kyle S

0

Answer 1

Hello Rob. The best option for a 30 amp lithium compatible converter is the Progressive Dynamics 9300 Series RV Converter Charger #PD49RR. I do have to caution against cutting off the plug since this will void your warranty. If you are comfortable…

view full answer...

Answer 2

We do have a 30 amp, 12 volt power converter, including one that can be used for either lithium or non-lithium batteries: - Progressive Dynamics 9300 Series RV Converter Charger - 12V - 30A #PD49RR

view full answer...

Answer 3

The 12v accessory pin from the 7-way would need to be connected to the battery in order to charge it so you'd first need to make sure it was actually wired that way since not every manufacturer does. That being said the trickle charge coming from…

view full answer...

Answer 4

The PD9140A is a converter that has the smart charger setup built into it so the correct pendent would be the part #PD92201.

view full answer...

Answer 5

Hey Lars, I would go with a higher rated Progressive Dynamics converter like the #PD79RR which is rated for 60 amps because while your RV has 30 amp power that's on the AC power side of things and this converter takes that AC and converts it to…

view full answer...

Answer 6

Hey Dan, thanks for reaching out! Without knowing what your inverter is rated for I'm kind of flying in the dark here, but a solid starting point in a replacement inverter is the Progressive Dynamics 1000 Watt Pure Sine Wave Inverter #PD34FR. You…

view full answer...

Answer 7

Hello Bob, Yes, you can plug the Progressive Dynamics 9300 12V 30A converter charger #PD49RR into the 110V outlet on your Bluetti AC200 Elite and wire it to your Blue Sea panel for 12V devices. Use 10 AWG wire (or 8 AWG for longer runs over 10 feet)…

view full answer...

Answer 8

Hi Omar, Typically on an enclosed trailer the battery will either be mounted to the tongue or will mounted inside at the nose of the trailer to make connecting to a 7-way junction box easier. This can be done with a battery box on the outside of the…

view full answer...

Answer 9

Thanks for reaching out to us, Mary! Amazon isn't the only place that has 12V converters - we have them here at etrailer as well! Ultimately, you'll need an AC/DC Distribution Panel like the 35 Amp #PD4135K, but if you already have one of…

view full answer...

Answer 10

Your older PD9145C charger delivers 45 amps of DC charging power at 13.6 volts DC. (For AGM batteries) This converter/charger requires 725 watts of AC power to operate. It also needs to be on its own AC circuit. The Progressive Dynamics #PD79RR…

view full answer...

Answer 11

I have another option for you, but no, the Go Power! #34266167 will not work with Lithium batteries as it's only designed for lead acid and AGM batteries. Instead you'll need the #PD49RR which was designed to be compatible with the higher…

view full answer...

Answer 12

On a 30 amp trailer with lithium batteries you will want to stick with the Progressive Dynamics 9300 Series RV Converter Charger #PD49RR. Only the amperage output is higher on the 40 amp converter; the efficiency is exactly the same for both.

view full answer...

Replacement 30 Amp Converter For Travel Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching