Recommended Towing Mirrors For A 2004 Ford Ranger

Question

Question:

I need .irrows for 2004 ranved sorry ranger

asked by: Jesse S

0

Expert Reply:

For your 2004 Ford Ranger I recommend the Longview Custom Towing Mirrors - Slip On - Driver and Passenger Side # CTM2200A. These custom-fit slide on towing mirrors have arms that tighten down with knobs to give you peace of mind knowing that your towing mirrors aren't precariously attached like some universal mirrors are. They have a mirror face dimension of 4-3/8" wide x 5" tall to extend your line of sight and first surface plating that minimizes distortion and glare.

expert reply by: Kevin C

0

Answer 1

Thanks for the picture of the mirrors you have on your 2004 Ford Ranger. From that I can tell that the The Original Custom Towing Mirror Slide-On Mirrors #CTM2200A that you referenced are a confirmed fit and will work well.

view full answer...

Answer 2

The The Original Custom Towing Mirror Slide-On Mirrors (Pair) Item #CTM2200A are a confirmed fit for all models of the 2004 Ford Ranger so you'll be good to go with these on your 2004 Ford Ranger Supercab XLT. These slip on mirrors provide…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

Hey Scott! Your 2026 Ford Ranger may or may not have a brake controller port/plug, even with the tow package. There will be four wires coming out of a large wire harness by the driver side firewall, left of the brake pedal, which can be wired to the…

view full answer...

Answer 8

Using the cut off wiring harness you have for the P3 part #90195 you will wire it to the brake controller wiring of your 2023 Ford Ranger which is sticking out of the large wire harness that goes through the driver's side firewall, left of the…

view full answer...

Answer 9

Hello Fred, thanks for reaching out. We do have brake controllers that can be used on your 2025 Ford Ranger, but I am sorry to say we do not have anything with a custom pigtail for the factory under dash EBC plug. All of the options we have at this…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

Hey Ken! The correct wiring harness depends on whether or not you have the brake controller port/plug. Some models did not include the plug so you will have to check your 2025 Ranger and see. There should be four wires coming out of a large wire…

view full answer...

Recommended Towing Mirrors For A 2004 Ford Ranger

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching