Where is Brake Controller Wiring on 2023 Ford Ranger

Question

Question:

I have a Tekonsha Prodigy P3 Trailer Brake Controller that I had installed in a Jeep Cherokee. I just got a 2023 Ford Ranger and would like to install the brake controller in it. I kept the Cherokee wiring and can cut of the vehicle end for connecting wires. I do need wiring instructions however. Can you help?

asked by: Anthony E

0

Expert Reply:

Using the cut off wiring harness you have for the P3 part # 90195 you will wire it to the brake controller wiring of your 2023 Ford Ranger which is sticking out of the large wire harness that goes through the driver's side firewall, left of the brake pedal, with shrink tubing on the ends. The wiring on your truck will have it's functions labeled but for the brake controller wiring the red is for the stoplight circuit, black is for 12 volt power, white is for ground, and blue is the output circuit carries the braking power to the 7-way.

expert reply by: Jameson C

0

Daniel H.

3/28/2024

I too have a recently purchased 2023 ford ranger with the factory trailer tow. I have the p2 controller which is not the issue i’m having. My question is after looking, where you advised Anthony, I am unable to locate any thing that resembles a pigtail plug coming from the main harness. I called two different Ford service departments and they both asked their techs and they don’t know. Each dealer wanted me to take it to their shop to look for it. With the trailer tow it should certainly have something. The owners manual say’s if towing over 1500 # to buy a after market controller. Very vague. My 2017 ram, 2019 ram and 2021 gladiator all had plugs under the dash. Any help would be greatly appreciated and if your company sells that pig tail to plug into it Would you please give me a part number.? Thanks, Dan

Reply

Jameson C.

3/28/2024

@DanielH We don't have a custom fit harness unfortunately. Ford in recent years has made the brake controller install connectors difficult on vehicles that previously had them. Your situation is pretty frustrating and only solution I can think of would be to take it to a dealer like you mentioned and see if they can find it.

Reply

Answer 1

Hey, Stephen! We got just what you need. Since you don't have a tow package, I'm not sure if you have a hitch on your 2025 Ford Ranger so I'll include one just in case. Draw-Tite Max-Frame Trailer Hitch Receiver Part #DT35PR Curt…

view full answer...

Answer 2

Hello Fred, thanks for reaching out. We do have brake controllers that can be used on your 2025 Ford Ranger, but I am sorry to say we do not have anything with a custom pigtail for the factory under dash EBC plug. All of the options we have at this…

view full answer...

Answer 3

There are 2 different options for your 1996 Ford F-350 8' Bed with running boards and they just depend on what kind of trailer hitch you have installed on your pickup. The correct front mount tie-downs are in the part #TLF2000. If you have the…

view full answer...

Answer 4

I checked with Torklift and the correct tie downs for your 1995 Ford F-350 that has running boards that run under the bed of the truck are part #TLF4000 and #TLR3501.

view full answer...

Answer 5

To determine if your motorhome has the Tiffin air brake setup or Freightliner BrakeSync you'll need to look at the rear and see if there's an quick disconnect fitting for your air line. The standard Tiffin air coupler fitting would look like…

view full answer...

Answer 6

If you want the best, it's the MORryde Rubber Equalizers for Tandem Axle Trailers part #MR87ZR. These are the best as they offer the most travel which is basically how much that rubber bushing compresses and the more it compresses, the better…

view full answer...

Answer 7

For the Road Armor Equalizers #LC696740 you're going to install on your trailer, you don't have to install the premium MORryde Wet Bolt Kit #MR76ZR you were looking at if you don't want to spend that much, you could go with the Lippert…

view full answer...

Answer 8

Yes. You can use the MORryde Suspension Upgrade Kit for Tandem Axle Trailers w Correct Track - 2-1/4" Shackle Straps #MR58ZR without critically changing your trailer's setup. It is important to note that this particular kit is designed to…

view full answer...

Answer 9

Hey Jacques, thanks for reaching out! The Redarc Tow-Pro Liberty #RED52VR will work just fine on your 2023 Ford Ranger, and it will install by splicing into a bundle of wires under your driver side dash. We have a video of this same process of the…

view full answer...

Answer 10

There is not a specific range that that is limiting in regards to the distance between the ICX transmitter and monitor for the Roadmaster Even Brake Portable Supplemental Braking System #RM-9400, and will absolutely work on a 40 foot motorhome…

view full answer...

Answer 11

Yes, the Demco Vacuum line connector part #DM6257 will install in your 2021 Ford Ranger just like the F-150 you saw when you go to install the Air Force One #SM99209.

view full answer...

Answer 12

Hey Mike, Assuming you are using the Curt Custom Base Plate Kit #C64ER or Blue Ox Base Plate #BLU77XR on your 2021 Ford Ranger, then the best choice really is the etrailer SD Non-Binding Tow Bar for Blue Ox and Curt Base Plates #e47ZR. It's a…

view full answer...