Will the Excel RV Tankless On-Demand Water Heater Replace a Tank Style RV Water Heater

Question

Question:

can this be installed in place of the standard RV tank type water heater?

asked by: Keith G

0

Expert Reply:

The Excel RV Tankless On-Demand Water Heater part # EX93FR will work to replace a standard tank style water heater no problem. That said, the fittings and connections may not be the same so worse case you might need some simple adapters you can obtain locally. The dimensions are likely different as well with the above measuring 11-5/8" wide x 14-5/8" tall x 4-1/2" deep.

expert reply by: Conner L

0

Answer 1

Per the manufacturer, Excel, the Excel RV Tankless On-Demand Water Heater #EX93FR has to be installed upright with the vent facing upwards.

view full answer...

Answer 2

We have a lot of different options in tankless water heaters, but you did not list what water heater you currently have installed so I am not apple to find a direct replacement for you. Without information I recommend The Excel RV Tankless Water…

view full answer...

Answer 3

Yes, if you pipe the Excel RV Tankless Water Heater #EX93FR in parallel with another unit then it would draw equally from both units. These unit would need to be side-by-side and have an equal length of pipe to keep both equalized instead of drawing…

view full answer...

Answer 4

Those are all great questions, lets see what I found out about the Excel. **Excel RV Tankless Water Heater - Gas - Electric Ignition - Vent Free - 38,000 Btu #EX93FR. *Fogatti RV Tankless Water Heater - Gas - Automatic Pilot - 41,800 Btu - White…

view full answer...

Answer 5

There could be many reasons why your Excel RV Tankless Water Heater #EX93FR suddenly stopped heating but I can give you some things to check first before moving onto further troubleshooting. The first thing I would make sure is that nothing is…

view full answer...

Answer 6

Shawn, for the Excel RV Tankless Water Heater #EX93FR you can use the Camco Single Stage Propane Regulator #CAM59013. This regulator is rated for up to 200,000 Btu, has a 1/4" female NPT inlet, and a 3/8" female NPT outlet.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Will the Excel RV Tankless On-Demand Water Heater Replace a Tank Style RV Water Heater

Product Page this Question was Asked From

Continue Researching