Cover Recommendation for 2020 Rockwood 2280BHESP

Question

Question:

Pop up camper cover selection advice -Pop up camper: 2020 Rockwood 2280bhesp -box length 14 feet -add 2 and ½ feet if covering metal gated cargo carrying front -it is lower than the roof of pop up -should I cover it, too? -cover used mainly in winter to protect against snow and ice -location -NY Finger Lakes area -cold and snow -late Nov. to mid March -can get windy at times Considering Aquashield -up to 16 ft. or Campco Ultra Guard 14-16ft Or if you have something else you would advise to get. Also looking at 2015 Toyota Sienna front wheel drive suspension assist pop up about 2500 lbs unloaded -will be about 3000 loaded. Which suspension assist would you suggest and where would I get it installed? Thank you for any advice regarding these questions -you have great and helpful videos!

asked by: Steve R

1

Helpful Expert Reply:

For the length of your 2020 Rockwood 2280BHESP the best storage cover for the climate you mentioned would be the Aquashed SFS part # 290-12295 that you referenced. This fits the best and will do the best in your winter climate.

Then for air bag suspension support for your 2015 Toyota Sienna the Firestone kit part # F4155 would do an excellent job giving you additional support when towing.

expert reply by: Jameson C

1

Answer 1

I recommend the Curt Echo Wireless Trailer Brake Controller - 1 to 2 Axles - Proportional Item #C51180. If the dealership is installing the 7 pole connector, this controller doesn't require any additional wires to be ran inside the vehicle. Your…

view full answer...

Answer 2

I spoke with my contact at Reese and since the Friction Sway Control Kit, #83660, has not been tested on a Rockwood Freedom Pop-Up Camper trailer, we can not guarantee that the support mount on your trailer would not interfere with the operation of…

view full answer...

Answer 3

We have just what you'll need but let's start with the weight distribution system. You gave the exact right figure for picking out a WD system since it's based off the loaded tongue weight plus weight of any cargo behind rear axle. So you…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Cover Recommendation for 2020 Rockwood 2280BHESP

Products Featured in This Question

Continue Researching