Spare Wheel and Tire for Apogee Adapt X-300 Trailer

Question

Question:

I have an Apogee Adapt X-300 trailer. I was interested in purchasing a spare tire with the wheel. Do you sell?

asked by: Erik R

0

Expert Reply:

The Apogee Adapt X-300 uses the tire size ST175/80R13 on a 5 lug wheel so for a spare you'd want the # AM31994 and you'd be set.

expert reply by: Jameson C

0

Answer 1

The Apogee Optimax Folding Utility Trailer will use a bias ply tire. Specifically it is a 5.30-12 tire with a load range C. For a spare tire I recommend the Kenda 5.30-12 Bias Trailer Tire with 12" Galvanized Wheel #AM30850. You can mount this…

view full answer...

Answer 2

The Apogee Adapt-X 500 folding utility trailer, like #AT74FR does not include a spare tire holder. You can certainly add one, but the problem lies in finding a spot to install a spare tire without interfering with the trailer's ability to fold.…

view full answer...

Answer 3

You should always follow what is printed on the side of the tire from the trailer tire manufacturer. Tires inevitably get replaced over time so what was printed on the trailer will no longer be accurate. For trailer tires, this will typically be the…

view full answer...

Answer 4

The wheel and tire combos we sell are not balanced at the factory. When the tire is mounted to the wheel, the high (heavy) spot on the wheel is matched to the low (light) spot on the tire, which leaves the wheel and tire somewhat balanced. You may…

view full answer...

Answer 5

We may be able to help you out, although the reason you cannot find 14 or 15 inch tires that are smaller than a ST205/75R14 is because that is the smallest size, and they are 8 inches wide. For a narrower tire you will need to get smaller, 13 inch…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Spare Wheel and Tire for Apogee Adapt X-300 Trailer

Product Page this Question was Asked From

Continue Researching