Lift Kit that Fits Jayco 1006 Pop-Up Camper

Question

Question:

Hi, Would this be the correct lift kit for a 2005 year Jayco Jay Series model 1006 pop up camper? There is a sticker on the axle that I believe has the part number Dexter#:48773 attached photo. Thanks!

asked by: Travis

0

Expert Reply:

I forwarded the info you sent to Dexter and they were able to determine that your 2005 Jayco Jay Series 1006 pop up has Dexter #9 Torflex axles so for a lift kit you'd want the part # K71-723-01. This will give you a lift of 2-5/8 inches.

expert reply by: Jameson C

0

Answer 1

I may have a solution for you, but we don't carry any true pneumatic wheels for swiveling trailer jacks-they're typically only going to be used on heavy duty trailer jacks and dollies like the Trailer Valet #STC-V211. With that said, you may…

view full answer...

Answer 2

Hello Justin, Yes, we do have some options with the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire - Load Range E #AM10140 already mounted to a wheel. They are all a 5 on 4 1/2" bolt pattern: - Karrier S-Trail Radial Trailer Tire with…

view full answer...

Answer 3

The Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire - Load Range E #AM10140 and the Aluminum Lynx Trailer Wheel - 12" x 4" Rim - 5 on 4-1/2 - Silver #LH45FR is the wheel and tire that you want. There is very little difference between…

view full answer...

Answer 4

I have a solution for you, but we do not have any 12 inch, 4 lug tire and wheel combos that will allow you to exceed the GVWR of your pop-up camper. The only 12 inch trailer tire we offer that will allow you to exceed your trailer's GVWR is the…

view full answer...

Answer 5

The Dexter Axle Torflex axles are basically broken up into the following categories: #9 - 1,000 - 2,200 lb #10 - 2,300 - 4,000 lb #11 - 4,100 - 6,000 lb #12 - 5,500 - 7,200 lb Based off of your 2004 R-Vision Trail-Lite Model 8306S being a tandem axle…

view full answer...

Answer 6

The closest matching trailer taillight we offer to what you mentioned is the part #STL0016RB for the passenger side and part #STL0017RB for the driver side. These are both 8-5/8" x 2-7/8".

view full answer...

Answer 7

Your photo of your Jayco pop-up does appear to show a corroded outer roller bearing along with your 5.70-8 tire and 4-on-4 wheel, such as #AM30153 and the similar items shown on the linked page. Your size wheel/tire is usually found on an axle rated…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Lift Kit that Fits Jayco 1006 Pop-Up Camper

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching