Where Is The Factory Trailer Brake Controller Port In A 2011 Dodge Durango?
Updated 10/04/2021 | Published 10/03/2021
Products Featured in This Question
Question:
I can not find the wiring harness for my 2011 durango left of the emergency brake and have had the whole bottom of the dash off and the center console off and no where to be seen
asked by: ROY C
Expert Reply:
The factory trailer brake controller port in your 2011 Dodge Durango will be located underneath the dash near the emergency brake pedal, but can be pretty hard to find. If you take a look at the 4:22 minute mark of the included video of the Tekonsha Prodigy P2 # 90885 with plug-in adapter # TK93VR being installed you will see where we have found the connector on a similar 2013 Dodge Durango.
Keep in mind this port will only be there if your vehicle has the factory 7-way connector. If you do NOT have the factory 7-way connector you will need to go a different route.
You would first need to install a 4-way connector # 118552, then a 7-way connector # ETBC7.
You would then need to hardwire the controller to your vehicle following the included help article.
Let me know if your vehicle has the factory 7-way connector or not and I would be happy to make sure you get the correct components.
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: generators
- Shop: Camper Tie-Downs
- Shop: Trailer Hitch
- Video: Installing the TorkLift Tie Downs on your 2023 Ram 3500
- Q&A: Recommened 5th Wheel Hitch for a Flat Bed Truck w/ a Recessed Well
- Shop: TorkLift Tie Downs - Custom Frame Mount - Front and Rear
- Search Results: 106183
- Search Results: lp detector
- Shop: TorkLift SuperHitch Magnum Trailer Hitch Receiver - Custom Fit - Class V - 2-1/2" and 2"
- Shop: E-Z Flex Equalizers - Double-Eye Springs - Tandem Axle - 8,000 lbs - Qty 2
- Shop: Front/Center/Rear Hanger for Double-Eye Springs - 3-1/4" Tall - 9/16" Bolt Hole
- Search Results: 520900
- Search Results: rv surge protectors
- Search Results: a32abp
- Search Results: vacuum breaker
- Shop: Replacement Gear Pack for Lippert RV Slide-outs w/2-1/2" x 2-1/2" Arms - Heavy Duty
- Q&A: How To Determine Which Replacement Gear Pack To Use on Lippert Slide Out
- Shop: Curt Ball Mount for 2" Hitches - 2" Rise, 4" Drop - 8-1/4" Long - 7,500 lbs
- Shop: Mighty Cord RV Extension Cord w/ Pull Handle - 30 Amp - 25'
- Q&A: Determining if Ranch Hitch Will Work with Recessed Gooseneck Ball on Flat Bed
- Q&A: Will The Gen-Y 5TH Wheel To Gooseneck Pin Box Work On Flatbed With Recessed Hitch Ball?
- Q&A: Will Gen-Y Gooseneck Pin Box Work with Flatbed Truck
- Shop: Suspension Enhancement
- Q&A: How to Install the TorkLift StableLoad Part # TLA7200 on a 2003 Ford F-350
- Shop: Base Plate for Tow Bar
- Shop: Vehicle Tow Bar Wiring
- Shop: Vehicle Tow Bar Brake System
- Shop: RV Interior Lighting
- Q&A: Rubber Boot Service Kit For Power Gear Leveling Jack Motor 1010000155
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
on Accessories and Parts
