Replacement Pins for Ram 12000 Jack

Question

Question:

Are the shear pins for a 12000 lb ram jack available for purchase?

asked by: Derek H

0

Expert Reply:

We have the Replacement Sidewind Gear Kit for etrailer and Ram Square, Direct Weld Jacks # TJD-12000-GR which does include 2 roll pins. This is for the TJD-12000 Series jacks. If that is the jack you have then these will work. If you have a different jack please let me know what jack you have and I can help you locate the correct part you are looking for.

expert reply by: Scott S

0

Answer 1

Yes, we have heard back from our customers that the Bulldog Powered-Drive Kit for Single-Speed Jacks part #BD1824200100 will also work on 12,000 lb RAM jacks like the Square Direct Weld Jack part #TJD-12000SP-R2. I would have to agree as well because…

view full answer...

Answer 2

Good job trying the second trailer, that really helps diagnose things. Since your Tundra has the factory tow package, the turn signals are converted through the tow package. The likely cause of what occurred is a short circuit somewhere in the…

view full answer...

Answer 3

I went ahead and reached out to RAM and they explained to me that to re-install your inner leg to your RAM jack like the Square Direct Weld Jack - Drop Leg w/ Spring Return #TJD-12000SP-R2NH, you are going to need to re-install the lower pin, replace…

view full answer...

Answer 4

Hey John, the replacement gear kit you'd need is the part #TJD-12000-RODNUT which I attached two pictures that have instructions and an install diagram.

view full answer...

Answer 5

The Replacement Gear Kit for Bulldog Sidewind Jacks w/ 12,000-lb Capacity #BD500212 are not a confirmed fit for all 12K legs. I've attached a photo with measurements to help you determine if this gear kit will work for your application. The…

view full answer...

Answer 6

To repair a Ram Series 12000 jack, like #TJD-12000SP-R2, we have the Gear Kit #TJD-12000-GR or the Replacement Rod and Nut #TJD-12000-RODNUT. Or you could need both. I just depends on what the problem is exactly.

view full answer...

Answer 7

Good news! I was able to get a exploded diagram as well as a set of instructions on how to replace the rod and gears #TJD-12000-RODNUT in the #12000 Series Ram Jacks made after 2012. I have attached them to this page for your convenience. Basically,…

view full answer...

Answer 8

Hi George, The Curt Replacement Lifting Nut part #C93NR is specifically designed for the Curt 28512 heavy-duty weld on jack so it will not work as a replacement for a Bulldog jack. Bulldog jack parts are typically model-specific so even if they look…

view full answer...

Answer 9

It sounds like you're talking about the rod and nut on the #TJD-12000SP-R2NH. We have the following replacement parts available: -Replacement Rod and Nut for etrailer and Ram Square, Direct Weld Jacks #TJD-12000-RODNUT -Replacement Sidewind Gear…

view full answer...

Replacement Pins for Ram 12000 Jack

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching