Will the Thule Airscreen XT Fairing # TH62WV Fit My 2020 Subaru Outback?
Published 09/17/2021
Question:
The length of the bar from the inside to inside factory side rail is 37” The width of the bar is 2 and change and the height is below 1-1/8 so I think we’re good to go. Just confirm that the small is the correct fit and I will place my order.
asked by: James A
Expert Reply:
The Thule AirScreen XT for Thule Crossbars - 32" Long # TH62WV will be able to fit your factory crossbars on your 2020 Outback Onyx XT as long as the dimensions of your crossbars do not exceed 3-1/8" wide x 1-1/8" inches tall. I recommend measuring your crossbars to make sure they do not exceed these dimensions.
As far as what the length of your fairing, you want your fairing to ideally be within about 6 inches of your total crossbar length without going over the length. Unfortunately, I do not have the exact measurements of the length of the crossbars on your vehicle, but if you provide me that measurement, I would be happy to recommend you the right size fairing.
Product Page this Question was Asked From
AirScreen XT for Thule Crossbars - 32" Long
- Accessories and Parts
- Roof Rack
- Fairings
- 32 Inch Long
- Thule
more information >
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Video: How to Set Up Your Curt Trailer Hitch Receiver on a 2023 Mazda CX-30
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: Roof Rack
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Can Roof Rack Fairing Rest on Sun Roof
- Shop: Rhino-Rack Vehicle Strap Anchors for Bow/Stern Tie-Downs - Qty 2
- Shop: Yakima WindShield Fairing for Roof Racks - 34" Long
- Shop: Suspension Enhancement
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Search Results: trailer hitch
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Article: Trailer Wiring Diagrams
- Search Results: trailer wiring
- Q&A: Clearance Differences Between Hitches For A 2026 Honda Odyssey EX-L
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Video: Curt Powered Tail Light Converter Installation - 2023 Kia Telluride
- Search Results: trailer tires and wheels
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Video: Clean Up Your Trailer Wiring
- Article: How to Measure for Trailer Hitch Drop
- Search Results: trailer hitch ball mount
on Accessories and Parts
James A.
1/1/0001
The length of the bar from the inside to inside factory side rail is 37” The width of the bar is 2 and change and the height is below 1-1/8 so I think we’re good to go. Just confirm that the small is the correct fit and I will place my order.