How Does 00 Gauge Wire Get Installed In Pollak Single Pole Connector PK11852?
Updated 09/14/2021 | Published 09/13/2021 >
Products Featured in This Question
Question:
Hello, how wire connects to the terminal, what will hold it as there is a hole but no nut to tighten the wire inside the terminal
asked by: Rouslan
Expert Reply:
The 00 Gauge wire you have will need to get soldered to the the Pollak Single Pole Connector # PK11852.
You will remove the front portion of the connector by removing the screw on the front portion of the connector and then pulling the front part of the terminal out. Next push the wire through the rear of the connector, strip off enough of the the wire insulation to go into the terminal, then solder it on.
Before doing this you can also add the Cable Guard # PK11763 to protect your wire.
I included videos of the products mentioned for you to take a look at.
Product Page this Question was Asked From
Pollak Single-Pole, Round Pin Trailer Wiring Connector - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 1 Round
- Plug Only
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Redarc In-Vehicle BCDC Battery Charger - Dual Input - DC to DC - 12V/24V - 25 Amp
- Shop: Pollak Single-Pole, Round Pin Trailer Wiring Connector - Trailer End
- Shop: NOCO AC Port Plug with Dual Extension Cords - 18" Long
- Shop: Redarc In-Vehicle BCDC Trailer Battery Charger - Single Input - DC to DC - 12V/24V - 12 Amp
- Shop: NOCO Genius Smart Battery Charger - AC to DC - 6V/12V - 10 Amp
- Search Results: redarc smart rv
- Q&A: Male and Female Single Pin and 2-Way Pins for Trailer Wiring
- Q&A: Single Pole Trailer Wiring Connector for Battery Charge Line for RV
- Q&A: What Gauge Wire Should Be Used To Install A Samlex 1000W Inverter In A Truck With An In-Bed Camper
- Q&A: Quick Disconnect Socket for Charging a Battery
- Q&A: Is the Ring Terminal Attached to the Housing of the Pollak Single-Pole Connector a Ground
- Q&A: Max Wire Gauge Rating for Use with Pollak Single Pin Connector and Socket
- Q&A: How To Run Large Gauge Wire Between Truck and Trailer
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Search Results: trailer wiring
- Article: How to Measure for Trailer Hitch Drop
- Shop: Trailer Wiring
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Shop: Suspension Enhancement
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Search Results: trailer jack
- Video: Clean Up Your Trailer Wiring
- Search Results: trailer tires and wheels
- Shop: Brake Controller
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Video: In-Depth Look at the B&W 5th Wheel to Gooseneck Pin Box
- Search Results: trailer hitch ball mount



