Male and Female Single Pin and 2-Way Pins for Trailer Wiring

Question

Question:

will PK11851 work with 337TC1002? Will PK11852 work with 337TC2002 or is there a different rubber boot seal that works? What gauge wire comes with DL25215? I am trying to make sure all of this works with above connectors. You guys are great, Thanks

asked by: James S

0

Expert Reply:

I think you may have your part numbers swapped around but the part numbers you mentioned all can work together.

The 2-ways part # 337TC1002 and # 337TC2002 are perfectly compatible with each and the single pins # PK11851 and # PK11852.

expert reply by: Jameson C

0

Answer 1

The #PK11761 measures 1- 7/8 inch inside diameter at the larger open end, the #PK11762 measures 7/8 of an inch inside diameter at the larger open end. You can see these dimensions in the photo I produced for you.

view full answer...

Answer 2

Hey Jerry, The power and ground wires should be the same gauge so if your Samlex 1000w inverter calls for 2 gauge wiring for the power the ground would also need to be 2 gauge wire. If you're going further than 3 feet with the wire while…

view full answer...

Answer 3

The Pollak Single-Pole, Round Pin Trailer Wiring Socket #PK11851 and plug part #PK11852 are rated for 300 amps of continous use like you mentioned. They can accept up to 00 gauge wire which is very thick.

view full answer...

Answer 4

The 00 Gauge wire you have will need to get soldered to the the Pollak Single Pole Connector #PK11852. You will remove the front portion of the connector by removing the screw on the front portion of the connector and then pulling the front part of…

view full answer...

Answer 5

If you are looking for a single pole connector to use as a charge line for the batteries of your RV the part numbers #PK11851 and #PK11852 would be a great choice. These connectors can accept wire gauge up to 00.

view full answer...

Answer 6

As long as you do not exceed the 300 amp rating of the Pollak Single-Pole, Round Pin Trailer Wiring Socket part #PK11851 then this would work for you. For the male end of the above socket you would want to use the Pollak Single-Pole, Round Pin…

view full answer...

Answer 7

Yes, the ring terminal you see attached to the housing of the Pollak Single-Pole, Round Pin Trailer Wiring Connector #PK11852 that you referenced is used for a ground circuit. Check out the picture I attached that came from a customer who used this…

view full answer...

Answer 8

The only option we can offer to run a large gauge wire between the trailer and tow vehicle is with the Pollak Single-Pole, Round Pin Trailer Wiring Socket part #PK11851 and the Pollak Single-Pole, Round Pin Trailer Wiring Connector part #PK11852. The…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Male and Female Single Pin and 2-Way Pins for Trailer Wiring

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching