Opening Dimensions of Erickson Clamps for Truck Bed Toppers
Updated 11/07/2025 | Published 09/10/2021 >
Question:
I need the jaw opening to be 2.5inch minimum meaning it could fit a 2.5inch board between the jaws. I need the throat depth to be 1.5inch minimum. Do you have a drawing of your clamp?
asked by: Robert
0
Expert Reply:
I have attached below the dimensions for the Erickson Clamps for Truck Bed Toppers part # EM09453 at max opening.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Erickson Clamps for Truck Bed Toppers - 3-3/4" Long x 1-1/4" Wide x 3" Tall - Qty 2
- Accessories and Parts
- Tonneau Cover
- Clamps
- Erickson
more information >
Continue Researching
- Search Results: topper clamps
- Search Results: battery cable
- Video: Review of the Erickson Clamps for Truck Bed Toppers
- Shop: Replacement Clamps for Retrax Hard Tonneau Covers - Qty 4
- Shop: Replacement Clamps for Leer SR250 Soft Tonneau Covers - Qty 6
- Shop: Erickson Clamps for Truck Bed Toppers - 3-3/4" Long x 1-1/4" Wide x 3" Tall - Qty 2
- Video: Snap-Top Battery Box with Strap for Group 24 to Group 31 Batteries: The Breakdown
- Video: Review of CURT Trailer Wiring - Trailer End Cold Weather 7 Way RV Style Connector - C23RJ
- Shop: Curt Cold Weather 7-Way RV Style Connector - Trailer End - 10' Long - RV Standard
- Shop: Snap-Top Battery Box with Strap for Group 24 to Group 31 Batteries - Vented
- Q&A: Are these Bed Rails Compatible with My Husky 5th Wheel Hitch
- Q&A: Replacement Rubber Shim For Thule Xsporter Pro Adjustable Height Truck Bed Ladder Rack # TH500XTB
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Needing Replacement Knob And Base Assembly Cap For Thule Xsporter Pro
- Q&A: Smallest 13 Inch Trailer Tire
- Q&A: Kayak Carrier Recommendation for Leer Camper Shell with Thule Tracker 2 System
- Q&A: What is Difference Between Double Pivot and 360 Cushion for Fifth Wheel Hitch
- Q&A: Inside Dimensions for Furrion 2-in-1 Range Oven # FSRE17SABL
- Article: How to Install a Roof Rack
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: The 5 Best Trailer Drop Hitches You Can Buy



Diane
11/7/2025
Looking for a clamp to match our other clamps! Our 2013 leer topper is on our Ford F350 8' bed. Our existing clamps are larger than your dimensions above. Specifically, the opening height is 2 3/8" (not your 2 1/8) ; the lower width is 2 1/8 (not your 1 1/8); the upper width is 2 3/4 (not your 1 7/8). Can you please recommend a bigger clamp to match our other clamps? (The bolt rusted in one of our clamps and had to be drilled out - so we need to replace just one clamp). Thanks in advance for any assistance.