Width of Ultra Frame Weld On Class IV Hitch Receiver

Question

Question:

I need at least 42

asked by: Don S

0

Expert Reply:

I called the manufacturer and part # 41990, will accommodate up to a 44 inch frame.

We also have part # 41990-07 and 41990-16 which are both 44 inches wide with different size mounting brackets if these would fit your application.

expert reply by: Patrick B

0

Answer 1

For your 2003 Ford E-450 Cutaway chassis we have the Curt hitch part #14055 as the most likely fit. This fits the cutaway chassis vans as long as the mounting holes on the frame are 38-5/8 inches apart. I attached an install video for this hitch for…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 5

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 6

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

Thanks for your question, Brandon. We have everything you need. There are two different options depending on what wiring is already on your van. The first option is if your van already has a 4-flat connector at the rear. If it does, you would need…

view full answer...

Answer 9

Hey Donnie, I have great news we do have a front hitch that fits your 2004 Fleetwood Tioga with the Curt front hitch part #33055. This would work great for carrying a bike rack. What kind of bike racks do you have and do you have a bike rack…

view full answer...

Answer 10

Hi Ray, To add a front hitch to your 2000 Ford E-450 Cutaway, you can use the Curt Front Mount 2" Receiver Trailer Hitch part #33055. It is rated for 9,000lbs of line pull, has a vertical load of 500lbs, and a GWVR of 5,000lbs. It will bolt…

view full answer...

Answer 11

Hey Jim, I checked the install instructions for the Curt hitch part #33055 and they state that if a front plastic valance is present it will need to get removed. Sounds like that is what you are referring to and it would need to get removed.

view full answer...

Width of Ultra Frame Weld On Class IV Hitch Receiver

Continue Researching