bing tracking image
Q & A Icon

Best Front Hitch For 1999 Winnebago Mini Winnie On Ford E450 Chassis  

Updated 09/24/2026 | Published 09/22/2026

Question:

I have a 1999 Winnebago Mini Winnie on a E450 chassis. I also have a 16 aluminum boat that is difficult to see when launching so Im looking for a front receiver hitch. The one you have listed only shows F450 which Im sure has a different mount. Do you have one for me and if so how much would I be looking at.

0

Expert Reply:

Hey Kevin, thanks for reaching out. Yes, we do have a front receiver that fits your setup. The Curt Front Mount Trailer Hitch Receiver # 33055 is a custom-fit hitch for the 1999 Ford E-450 chassis, so it's a great match for your 1999 Winnebago Mini Winnie.

A lot of our fit guides list the chassis rather than the motorhome manufacturer, which is why you only saw the E-450 application. Since your Mini Winnie is built on the Ford E-450 cutaway chassis, the # 33055 is the correct hitch.

This hitch has a 2-inch receiver with a 500 lb vertical load limit and a 5,000 lb line pull rating, making it a great option for maneuvering your 16-foot aluminum boat around the launch ramp. It gives you a much better view of the trailer than backing with the rear hitch, making it easier to position the boat exactly where you want it.

You can see our current pricing below.

Where do you launch that 16' aluminum boat most often?

expert reply by:
0
Jesse M
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
(click to enlarge)
Curtiss K. profile picture

Curtiss K.

9/24/2026

I used step drill with a1/2" electric drill and slowly and carefully opened up the smaller hole in front on the frame the area where the hole needed to be elongated for the flat bolt I used a grinder type bit that eats metal on a drill worked excellent. Easy to install and fitting is good. Remember to tighten the nuts to 115 ft lbs fitting is for the E450.

Jesse M. profile picture
Etrailer Expert

Jesse M.

9/24/2026

@CurtissK Nice work! Glad to hear you got it done. Thanks for sharing!

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>