Radius Dimension of Buyers Products Handle part # 3370091405H

Question

Question:

HELLO, Looking for the radius measurment on the Replacement Handle for Buyers Products Heavy Duty Square Jacks Item # 3370091405H

asked by: SAM F

1

Helpful Expert Reply:

The radius dimension of the Buyers Products Handle part # 3370091405H is 14-1/2 inches.

expert reply by: Jameson C

1

Radius Dimension
(click to enlarge)

Barry

5/28/2025

I am looking for this style jack with roughly 18 inches from the bolt out to where you are holding the tape in this picture. Do you have one similar?

Jameson C.

5/28/2025

@Barry 18 inches out to the right in the picture or down?

Barry

5/29/2025

@JamesonC out to the right.

Jameson C.

5/30/2025

@Barry I wish we could help but we don't have any handles that wide/long.

Answer 1

It sounds like you're looking for a brake adjuster spring for your 10" brakes, so you can use the Replacement Manual-Adjuster Spring for 10" and 12" Electric Trailer Brake Assemblies #BP08-070; this part is 4-1/8" long. There…

view full answer...

Answer 2

Most of our 12 x 2 electric drum brake assemblies like Dexter left/right kit #23-112-113 use a 5-bolt mounting pattern but the Dexter brake kit #23-105-106-09 has both 4-bolt and 5-bolt mounting holes. I went to our warehouse and measured the spacing…

view full answer...

Answer 3

Are there any visible signs of wear on the magnets like exposed windings then that would indicate they need replacing. Magnets can go bad without showing visible signs of wear though. To see how to troubleshoot them check out the help article I…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Radius Dimension of Buyers Products Handle part # 3370091405H

Product Page this Question was Asked From

Continue Researching