Recommended Lockable Spare Tire Carrier For 5 on 5 Bolt Pattern Trailer Wheel

Question

Question:

I am looking for a spare tire carrier that is lockable and wondering if this will work with a 15” wheel with a 5 on 5 inch bolt pattern?

asked by: Will

0

Expert Reply:

Yes. The CE Smith Spare Tire Carrier - Lockable - Steel - 4-Lug and 5-Lug Wheels - 8-3/4" Long # CE27201 will fit your 5 on 5 bolt pattern wheels. There's also a version of this that comes with a padlock included with part # CE27202.

expert reply by: Erik B

0

Answer 1

Hi Clayton, The lock would work the same if you are also using nuts with the CE Smith Spare Tire Mount #CE27202. You'd still thread on the locking brackets and then use the padlock to secure it.

view full answer...

Answer 2

Yes, the CE Smith Padlock Brackets for Spare Tire Carriers item #CE26002Z-2 you were looking at will fit the CE Smith Spare Tire Carrier for Trailers item #CE22007Z-11050-2 and item #CE22011Z-11050-2. So if you purchased one of those two spare tire…

view full answer...

Answer 3

With the CE Smith trailer wheel spare carrier part #CE27201 you can mount the wheel vertically or horizontally.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Recommended Lockable Spare Tire Carrier For 5 on 5 Bolt Pattern Trailer Wheel

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching