What Wood is Used for CE Smith Bunk-Style Guide-Ons for Boat Trailers

Question

Question:

Is the wood inside the bunk guide-ons pressure treated? I have a bare aluminum Klamath boat, and I am concerned about corrosion from copper in the pressure treated lumber.

asked by: Ben

0

Expert Reply:

The wood used for the bunk boards on the # CE27660 CE Smith Bunk-Style Guide-Ons for Boat Trailers is not pressure treated. CE Smith uses untreated southern yellow pine for their bunk boards. These also feature marine-grade carpeting to protect your boat's finish.

I have attached a video review and installation for your reference.

expert reply by: Robin H

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 3

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 4

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 5

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 6

The BTR and BT8 denotations refer to the spindle, not the trailer hub. The difference between a BTR and BT8 spindle is that the BTR spindle uses a 1.063" diameter L44649 bearing and the BT8 spindle uses a 0.99" diameter L44643 bearing. In…

view full answer...

Answer 7

Hey Steven! The etrailer Rust-Resistant 3-Leaf Double Eye Spring for 4K Trailer Axles - 25-1/4" Long - Dacromet #e93SR will be adequate for your 2020 Gulf Stream Vista Cruiser since the Dexter D40 number correlates to a 4,000 lbs hub and drum…

view full answer...

Answer 8

Hello Randy, Great question. For replacing bunk boards on a 20 ft bass boat trailer (like #CE27845), you’ll want 3/8 inch diameter lag bolts that are 1-1/2 to 2 inches long, depending on the thickness of your bunk brackets. Go with hot-dipped…

view full answer...

Answer 9

Hello Chad, thanks for reaching out. The CE Smith Roller Style Guide-Ons for Pontoon Boat Trailers #CE27672 will work fine with a StarCraft tri-toon, assuming you’ve got a pretty standard bunk-style trailer under it. We’ve put those on plenty of…

view full answer...

What Wood is Used for CE Smith Bunk-Style Guide-Ons for Boat Trailers

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching