Which Happijac Truck Mounted Camper Tie Downs Fit 2011 Dodge Ram 2500 Long Bed

Question

Question:

Will the front tie down plates LC182871 work for my truck? The ones i have now were fitted for a 2006 RAM 2500. The plates dont match my new truck and all i need it the upgraded mounting plates i believe?

asked by: Daniel C

0

Expert Reply:

The part # LC182871 that you referenced is a replacement part for the tie downs that fit a Chevy truck. For your 2011 Ram 2500 you'd actually need the new setup of part number # LC236326-205221 which is an all new setup for your truck.

expert reply by: Jameson C

0

Answer 1

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Jim welcome back. To determine if you need the TorkLift Camper Anchor Relocation Kit item #TLA7004, you'll have to take a measurement. You'll want to measure from the front bumper of your Palomino HS2902 to the center of the rear anchor…

view full answer...

Answer 4

Hey Chris congrats on the new truck! I did some research and the HappiJac Camper Tie-Downs item #LC236326-205221 is exactly what you need for your 2026 Ram 2500. I'm working on getting our website updated as we speak. This kit includes both front…

view full answer...

Answer 5

Hey Christian, Yes, the TorkLift Tie Downs - Custom Frame Mount - Front and Rear #TL29DR will fit your 2016 Ram 2500 Crew Cab with running boards as long as you have a factory hitch receiver or no receiver at all. If your 2016 Ram 2500 Crew Cab with…

view full answer...

Answer 6

Hey Lyn, I had to re-read the date you sent in for your pump a few times to tell if you were being serious or sarcastic - your water pump is older than like half of my coworkers so that's pretty impressive that it lasted that long. The closest…

view full answer...

Answer 7

Hey David, it sounds like you know what you're doing but I've also gone ahead and found the wiring diagram for the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR for you to check out so you can use it as a cross…

view full answer...

Answer 8

Any powered landing gear or powered tongue jack will draw less power as it legs descend down toward the ground and much more as soon as they make contact and encounter resistance. This is a normal occurrence. In the same way, any jack - even a manual…

view full answer...

Answer 9

I took a look at the installation instructions (which are also linked) for the HappiJac Truck-Mounted Camper Tie-Downs #LC182910-182971 which is the Replacement Front Anchor Plates for HappiJac Truck-Mounted Camper Tie-Downs #LC182876 fit, and there…

view full answer...

Answer 10

We do have the replacement front anchor plates for the Happijac camper tie-downs for your 2005 Chevy Silverado 3500, with the correct part being the following: - Replacement Front Anchor Plates for HappiJac Truck-Mounted Camper Tie-Downs #LC182872

view full answer...

Answer 11

There is no weight capacity for the Brophy Clamp On Camper Tie-Downs #HSSF. The tie-down hardware kit #TDHP, that is used to secure the camper to the #HSSF tie-downs has a weight capacity of 3,000-lbs. My contact at Brophy said the tie-downs will…

view full answer...

Answer 12

I would be happy to help you. Removing the factory hitch is not necessary and will be difficult to remove based on how it was attached to your Ram 2500's bumper. Ultimately, it'll be up to you but it being on there will have zero effect on…

view full answer...

Which Happijac Truck Mounted Camper Tie Downs Fit 2011 Dodge Ram 2500 Long Bed

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching