Parts Needed to Upgrade Progressive Dynamics Converter for Lithium Battery

Question

Question:

I have the PD4590K18NS2B but need to be able to charge lithium battery now. I do not have the switch for LA or LI . Would this alone make it capable or do I need to change the whole panel?

asked by: Mark C

0

Expert Reply:

Yes. Even without the switch, you'll just need the Progressive Dynamics Replacement Lithium Converter for Progressive Dynamics 4500 Series RV Power Control Center - 90 Amp # PD4590LICSV to give you the ability to charge and maintain lithium batteries. I was able to confirm this with my tech contact at Progressive Dynamics as well.

expert reply by: Erik B

0

Answer 1

The Progressive Dynamics #PD4590CSV is designed as a replacement for the Progressive Dynamics RV Power Control Center #PD4590K18LS8. It is not made as a replacement for the WFCO 9990, and unfortunately we do not offer a converter section that will be…

view full answer...

Answer 2

I am not 100% sure what you are asking. The newer models of the power centers/converter sections like the Progressive Dynamics 4500 Series RV Converter #PD4590K18LS8 are coming with the switch that you are referencing that allows you to switch…

view full answer...

Answer 3

Yes, you do need to move the jumper over from the lead acid to the lithium setup and you'd have the higher voltage charging profile.

view full answer...

Answer 4

To replace just the converter section of your PD4590 series power center you'll need part #PD4590CSV. This is a direct factory replacement for a 90 amp PD4500-series power center, like you have.

view full answer...

Answer 5

I spoke to Progressive Dynamics, the Progressive Dynamics REL 90A 4500 Series Inteli-Power Converter Section part #PD4590CSV is a fit for you 4590 panel. You have an older style panel which uses a different fan layout but the above will fit and is…

view full answer...

Answer 6

The Replacement Converter Section for Progressive Dynamics 4500 Series RV Power Control Center - 90 Amp #PD4590CSV is the converter section you're referring to, so in most cases the converter can be swapped out for a new one. This converter would…

view full answer...

Answer 7

The Replacement Lithium Converter #PD4590LICSV is only for use on Lithium batteries. They offer the Replacement Converter #PD4590CSV for use on lead acid batteries. There is no switch on either converter which will allow you to charge the other type…

view full answer...

Answer 8

Hey David, so we don't have that at this time so you would need the part #PD4590CSV if it's a Lead Acid battery or the part #PD4590LICSV for if it's a lithium.

view full answer...

Answer 9

For charging lithium batteries you will need the Replacement Lithium Converter #PD4590LICSV for your Progressive Dynamics power center. The Replacement Converter Section #PD4590CSV is for lead acid and AGM batteries.

view full answer...

Answer 10

The design of the Progressive Dynamics 4000 Series Mini RV Converter #PD4045KA hasn't changed much, but the key is to look for the converter section. The switch is located on the converter's circuit board and will have in white "LA"…

view full answer...

Answer 11

Yes, you will be able to use the Replacement Lithium Converter #PD4590LICSV on your Progressive Dynamics PD4590K18LS2. I confirmed this information with Progressive Dynamics.

view full answer...

Answer 12

The picture that you sent in is of a PD4590CSV. The Replacement Converter Section for Progressive Dynamics 4500 Series RV Power Control Center - 90 Amp #PD4590CSV is also a PD4590CSV. So if you are asking if that can replace what you currently have…

view full answer...

Parts Needed to Upgrade Progressive Dynamics Converter for Lithium Battery

Product Page this Question was Asked From

Continue Researching