Correct Trailer Rim for 235/80-16 Tire

Question

Question:

I have a new ST235/ 80R16 tire for my 2021 Outdoors RV 24KRS camper. I am looking for a wheel/rim. Requesting which are the proper wheels from etrailer.com would work for this tire?

asked by: Michael O

0

Expert Reply:

A ST235/80-16 tire will fit on a 16 inch rim with a width of 6, 6-1/2, 7 or 7-1/2 inches. Threfore the # AM20742 rim you'd looked at would work well for you. The rim has a 6 on 5-1/2 inch bolt pattern and a 3050 lb capacity.

You'll also need valve stems like part # AM20906.

expert reply by: Mike L

0

Answer 1

The wheel on a trailer will typically always be higher than any tire that can be mounted. The limiting factory is the valve stem. A solid metal one, like the Americana Metal, Bolt-In Valve Stem #AM20906, will be rated to to 200 psi, whereas a valve…

view full answer...

Answer 2

Here is a list of our 16" steel trailer wheels which have the 6 on 5-1/2" bolt pattern. We will not have any wheels which have the 95.4mm pilot hole you are needing which should not likely be an issue since trailers will typically use a…

view full answer...

Answer 3

The diameter for the valve stem hole on the Aluminum Jaguar Trailer Wheel #274-000011 is 0.625".

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Correct Trailer Rim for 235/80-16 Tire

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching