How to Key BOLT Hitch Lock to 2021 Ram 1500

Question

Question:

My 2021 Ram 1500 has a key fob, do you use the emergency key contained in the Key Fob to code the Bolt Lock.

asked by: Rich H

1

Helpful Expert Reply:

Yes you'd use the emergency door key of your 2021 Ram 1500 to key the BOLT Trailer Hitch Receiver Lock # BL7018448 that you referenced.

expert reply by: Jameson C

1

Answer 1

You are correct that the Loadstar ST205/75D14 Bias Trailer Tire #AM1ST86 (K550) has a max rating of 50 psi and that should be when the tires are cold. Kenda has tested and approved this rating which also takes into account the heat build-up during…

view full answer...

Answer 2

We've checked with Curt and in addition to graphite grease, you can use the LubriMatic Mini Grease Gun w/ Multi-Purpose Grease #L30132 - the added bonus is that this mini-grease gun will fit in most tool boxes and hard to reach spaces.

view full answer...

Answer 3

I do have a possible solution for you to add sway control to your straight tongue trailer, but unfortunately adapters like part #RP58393 are not designed to be used with friction sway control units like you would find in the Kit #83660. If you have…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

How to Key BOLT Hitch Lock to 2021 Ram 1500

Product Page this Question was Asked From

Continue Researching