Correct Replacement Hub for CE Smith Multi Sport Trailers

Question

Question:

What HUB kit fit this trailer - need spares for a trip to NY from FL Need to order asap. Thanks

asked by: Chris M

0

Expert Reply:

The correct replacement hub for the CE Smith Multi Sport Trailers like part # CE48870 is the CE Smith Trailer Hub Assembly part # CE13311.

expert reply by: Conner L

0

Answer 1

Based on your photo it looks like you have 2,700 lb axles, and we do have hubs for that size axle. However, you will need to confirm the bearings your current hub has. You will need to take apart your current hub assembly and look at the bearings…

view full answer...

Answer 2

Hey Todd! The CE Smith Multi Sport Plus Boat and Kayak Trailer item #CE48870 uses item #CE13311 hubs. The correct replacement grease seal is item #34823, which has a inner diameter of 1.249" and an outer diameter of 1.983". Let me know in…

view full answer...

Answer 3

The CE Smith trailer #CE48870 that you referenced would use the bearings #L44649. If you ever needed a replacement hub you'd just need the part #CE13210.

view full answer...

Answer 4

Hey Andy, the trailer wheel and tire part #AM30670 should be inflated to 90 psi when cold under all circumstances and you'll be fine. Unlike on vehicles with trailer tires they need to be inflated to the max psi rating at all times so that you…

view full answer...

Answer 5

Since you are looking for a way to transport a kayak a much better solution for you would be a Yakima Rack and Roll trailer like part #Y08106 as this is rated for highway speeds. As always, exceeding posted speed limits is not recommended, especially…

view full answer...

Answer 6

Hey Keith, if you exceed the speed rating of your trailer tire you will end up overheating the tire and that will most likely cause it to fail. This is definitely going to be very likely if you are driving 12 to 14 hours at a time. Best option would…

view full answer...

Answer 7

We have a really great option for a trailer for your 10 foot Bass Pro Pond Prowler boat, although the Malone trailer you mentioned has been discontinued by the manufacturer and is no longer available. Instead, which I highly recommend is an option…

view full answer...

Answer 8

The speed rating of the CE Smith Multi Sport Plus Boat and Kayak Trailer w/ Bunks #CE48870 is 65 mph due to the tires that are on it. If you needed to go faster than that you can swap the tires out to the part #TT48012C which is the same size but…

view full answer...

Answer 9

You could use either the #AM30020 for a white painted steel wheel or the #AM30030 for a steel wheel with a galvanized finish. The tires that are included on the CE Smith #CE48810 trailer are manufactured by Kenda, the same company as the tires used…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Correct Replacement Hub for CE Smith Multi Sport Trailers

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching