Installation Video of Base plate for 2013 Kia Soul Manual Transmission ?

Question

Question:

Is there a video showing installation for the base plate for this Kia?

asked by: Lynn T

0

Expert Reply:

Unfortunately, we do not have an installation video for the Roadmaster # 522112-1 base plate kit. Roadmaster does not have one either. 2013 was the first year of the second generation, so it is difficult to say if there were any 2014 mods.

expert reply by: Les D

0

Answer 1

When flat towing your 2011 Kia Soul, there are a few things that are needed. You need base plates, a tow bar, safety cables, wiring for the towed vehicle lights, and a supplemental brake system. The base plates I recommend are the Blue Ox Base…

view full answer...

Answer 2

The base plate kit part #522112-1 will fit through the grille of your 2013 Kia Soul at the same height as the middle of your front license plate basically. You would need to measure from there down to the ground to determine the bracket height. The…

view full answer...

Answer 3

Thanks for the picture and information John! I would start out by replacing the gear item #LC369354 and the linkage item #LC369488. If that doesn't get your Kwikee Series 25 RV Steps up and running you should look into replacing the control unit…

view full answer...

Answer 4

First thing you will need is a base plate kit to flat tow your 2013 Kia Soul. For that you would want the Roadmaster Base Plate kit part #522112-1. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and…

view full answer...

Answer 5

The general reason a battery needs to be disconnected for flat towing is because there are certain functions that need to be disabled to prevent your vehicle's battery from draining. You wouldn't want to get to your destination and unhook and…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 9

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Installation Video of Base plate for 2013 Kia Soul Manual Transmission ?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching