Replacement Clearance Light and Turn Signal for 4-1/4 Diameter Light
Updated 04/30/2021 | Published 04/29/2021
Products Featured in This Question
Question:
I have a Clark Cortez motorhome that has 4 1/4inch tail and front turn signal lights. They are not as deep as part # A52AB. Wondering if you have something that is 4 1/4inch x 1/2? Thanks
asked by: Ben L
Expert Reply:
I may have a solution for you, but we don't have that exact light or one similar that is not an LED light; the # A52AB you were mentioning is just the lens and the light it goes on # ST52AA is not a close match for your old light. The light that is the closest match to your old 4-1/4" light are the LED Trailer Turn and Parking Light w/ Flange - Submersible - 10 Diodes - Round - Amber Lens # STL43ABX, which are 4" in diameter.
I will also add that mixing LED lights with incandescent lights can create problems with hyper-flashing on certain circuits that will need to be addressed by installing a resistor like the # DI34ZR on any circuit with a flashing light. You will need 1 resistor for each circuit that uses this light as a blinker.
Product Page this Question was Asked From
Dual-Face Trailer Parking/Turn Signal Light - Post Mount - 4" Round - Amber/Amber
- Trailer Lights
- Tail Lights
- Parking
- Turn
- Round
- Pedestal Mount
- Submersible Lights
- Incandescent Light
- 4-5/16 Inch Diameter
- Amber
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Search Results: heat shrink butt connector
- Q&A: Are Resistors Needed for Hyperflashing LED Lights?
- Shop: Optronics Load Resistor for LED Lights - Male PL-3 Plug and Female PL-3 Plug - Qty 1
- Q&A: LED Taillight Recommendation for 2004 Chevy Silverado Flat Bed Conversion
- Shop: Optronics Fleet LED Trailer Tail Lights w/ Grommets - Stop,Turn,Tail - Submersible - Oval - Qty 2
- Q&A: Are Load Resistors Required when Adding LED Lights to a Trailer
- Shop: Spring Latch w/ Holdback for Trailer Tailgate - 3" x 1-1/4" - Zinc Plated - Right Hand
- Search Results: tailgate latches
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Wiring New 3 Wire Light on Trailer to Replace 2 Wire Light
- Q&A: Replacement Steps For 2012 Chevrolet Silverado 2500
- Q&A: Identify Older Hayes Brake Magnet
- Article: Trailer Wiring Diagrams
- Q&A: Weight Distribution w/Sway Control Recommendation for 28ft Airstream Towed by Lifted F-250
- Article: Boat Trailer Guides: Which are the Best?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Types of Bumpers
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations