Where Is Running Light Relay On 2011 Nissan Pathfinder?

Question

Question:

38666-1 you suggested to put this fuse in the in-cab fuse box to get my running lights to work on my boat trailer. There is no place it will fit on my vehicle.

asked by: John B

0

Expert Reply:

For your 2011 Nissan Pathfinder the running light relay # C57000 you mentioned is located behind the passenger side kick panel as shown in the included picture.

This relay is a pretty common culprit to running lights not working on Nissan vehicles like your Pathfinder.

expert reply by: Samuel C

0

Running Light Relay Location On 2011 Nissan Pathfiner
(click to enlarge)

Jeff

3/17/2024

I have the same issue. When I pull this passenger side panel, I find wiring connections but do not see a place for a C57000 relay? Any suggestions or where specifically this can be found? Thanks!

Mike L.

3/19/2024

@Jeff What's the year and model of your Nissan?

Answer 1

For the 2012 Pathfinders the relays are located under the hood. There should be a small black box, take the lid off of the box and there should be a legend that will tell you where each of the relays goes. See attached picture.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 11

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 12

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Where Is Running Light Relay On 2011 Nissan Pathfinder?

Products Featured in This Question

Continue Researching