Can Sailun S637 Fit On Dexstar Conventional Steel Wheel # AM20758

Question

Question:

Can a Sailun S637 tire that 6.5inch wide be mounted on this rim?

asked by: Robert B

0

Expert Reply:

The Sailun S637 tire is sized ST235/85R16 which can fit on a 6 inch wide 16 inch diameter trailer wheel like the # AM20758 that you referenced.

expert reply by: Jameson C

0

Answer 1

We do not have a Kodiak disc brake caliper cross reference to automotive calipers but for the brake pads there are cross referenced parts. If you refer to the linked image you'll see a partial list of cross-compatibility of brake shoes for GM…

view full answer...

Answer 2

Hey Karl, so as long as your current wheel bolt pattern is 8 on 6-1/2 inch you can mount a 17.5 inch wheel and tire like the Westlake 215/75R17.5 part #LHAS701. The width and diameter of this size is going to be right at the same as your 16 inch…

view full answer...

Answer 3

It is not usually necessary to change wheel studs when switching from stamped steel trailer wheels to machined aluminum wheels like the Lionshead #LHSJ211G but I went to our warehouse to measure the thickness of the material at this wheel's hub,…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Can Sailun S637 Fit On Dexstar Conventional Steel Wheel # AM20758

Product Page this Question was Asked From

Continue Researching