2017 Thor Axis 25.3 RV Ford E-350 Chassis Sway Bar Recommendation  

When installing the end link kit part #RO57FR you do sometimes need to use a 1/2 inch drill bit to enlarge the holes on the sway bar. You do need to make sure you are using a drill bit designed for metal and not softer materials as they won't…

The Timbren Front Suspension Enhancement System part #TFEF350 is rated at 3,000 lbs and the Timbren Front Suspension Enhancement System part #TFEF350UH is rated at 6,000 lbs. I was able to call the manufacturer to confirm this. They will both fit…

The mounting holes the Curt Trailer Hitch Receiver #14053 measure 38-1/4" (for the 4 rearmost) and 38-3/4" (for the 1 forward-most) and then from the edge of the receiver that measurement is either 4-1/2" or 17-3/4" depending on…

The Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2" #14053 is a confirmed fit for the Ford Full Size Van but it is not a fit for a cab and chassis like you have which has a slightly wider frame. My recommendation due to the weight you…

I went out into our warehouse to measure the mounting flange of the Curt Hitch part #14053 that you referenced and found it to be 15-1/8 inches long.

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

In regards to the Roadmaster Exact Center Steering Stabilizer part #RM47MR, the stabilizer installs on the front of the steering arm pointed down. I have attached a photo of this below. If this wasn't what you were looking for, please just let me…

The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x 14 (and you used a 1…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I found the online version of the install instructions for the Exact Center stabilizers like the #RM47MR. What's fun is that just when you think you have found the correct step to address your problem it tells you to continue to the next step.…