Replacement Motor For Lippert 165046 Double Coach Step On A 2011 Tiffin Zephyr

Question

Question:

I need a step motor for my 2011 Tiffin Zephyr. There is no ID on the motor but the step is a LCI 165046 Dbl Slide 26. Do you have the replacement motor? THX,

asked by: Garth W

0

Expert Reply:

The replacement step motor for your 2011 Tiffin Zephyr Lipper Components double step is Item # LC301695. This is a direct replacement motor for the double and triple electric Lippert and Stromberg Carlson couch steps.

expert reply by: Shane H

0

Answer 1

Hello Tom, thanks for reaching out. We do have the Demco Air Force One Supplemental Braking System for Tiffin Chassis Motorhomes part #DM55MV. This kit includes the parts needed to install the Air Force One on your Jeep as your Tiffin chassis has the…

view full answer...

Answer 2

The correct replacement for your 300-1406 motor is the Replacement Motor for Lippert Electric Coach Step part #LC301695. If you need other components I would need more info on the steps as this specific motor fits quite a few different steps. If…

view full answer...

Answer 3

The Coach Air Kit for Air Force One Supplemental Braking System part #SM99627 includes the motor home installation components that come with the full kit Air Force One system part #SM99243. Keep in mind the coach air kit is only half the kit of a…

view full answer...

Answer 4

The Lippert 165046 upper slide assembly you have has been discontinued. We sell replacement parts for it but not the entire unit. The Replacement Motor for Lippert Electric Coach Step item #LC301695 Replacement Control Module for Lippert Electric…

view full answer...

Answer 5

I believe the part that you are looking for is included in the Replacement Joint Assembly Hardware Kit #LC216567. This includes that large black bolt that is on your Lippert Gear #LC301696.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Thanks for the information Kevin! To flat tow your 2025 Ford Bronco with a standard bumper and LED lights, I recommend the following parts: Tow Bar and Safety Chains - etrailer XHD Non-Binding Tow Bar for Roadmaster Direct-Connect item #e84ZR Base…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 12

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Replacement Motor For Lippert 165046 Double Coach Step On A 2011 Tiffin Zephyr

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching