Replacement Bearing Cover Options for Bri-Mar Dump Trailer

Question

Question:

I have a bri mar 5200lb dump trailer that needs new bearing cover. Is there one size diameter that fits that ? Thanks

asked by: Jay W

0

Expert Reply:

You will need one of two sizes depending on the axle capacity of your Bri-Mar dump trailer. If you have 7,000 lbs or 8,000 lbs axles, then you will need part # 21-43-1 and # DC-RP if you have EZ Lube spindles (grease zerk on the end) or you can use part # RG04-100 if you have standard spindles.

If you have 5,200 lbs or 6,000 lbs axles, then you will want part # RG04-080 if you have EZ Lube spindles or part # RG04-060 if you have standard spindles.

expert reply by: John H

0

Answer 1

Take a look of the picture I have included showing Curt trailer hitch #C13233 installed on a 2016 Volvo XC90. If you measure from the bottom of the piece pointed out in the picture down about 4-1/2 inches that is approximately where the bottom of the…

view full answer...

Answer 2

To install Curt trailer hitch #C13233 on your 2016 Volvo XC90 there is an underbody heat shield that will need to be trimmed, see the linked instructions, but the fascia/bumper does not have to be trimmed. I have included a picture of what the hitch…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 6

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 7

Yes the Stealth Hitch #SH27FRT fits your 2021 Volvo XC90 Recharge T8. You will also need to take your XC90 to your local Volvo dealership so a technician can reprogram the computer to send the proper signal with your new wiring. This is a fairly…

view full answer...

Replacement Bearing Cover Options for Bri-Mar Dump Trailer

Products Featured in This Question

Continue Researching