Compatible Roof Rack for 2021 Jeep Rubicon With Sky One Touch Soft Top?

Question

Question:

Does Thule make any racks for jeep rubicon 2021 with sky one touch soft top? Needs to clear the soft top remotely going back. I do have rain gutters.

asked by: Christopher S

0

Expert Reply:

One thing that may cause confusion is determining whether your Jeep has a hard Top or a soft top. If it has rain gutters, then technically, your 2021 Jeep Wrangler Rubicon has a hard top with a Sky One Touch Power Soft Top. The following recommendation is NOT a fit for Jeep Wranglers with total soft tops.

That being said, yes! There's a Thule rack that can fit your vehicle! The confirmed fit is the Thule System with 60" Long Wingbar Evo Crossbars # TH711520 and 5" Gutter Feet # TH300R, but when test fit on a 2020 Jeep Wrangler, there was on 2-1/2" of clearance between the bottom of the bars and the top of the roof.

I know your sky one touch roof folds up as it opens. If you take some measurements as it folds, you can see if 2-1/2" is enough clearance. If not, the the 8" Tall Gutter Feet # TH33ZR are a better fit for you. The 8" version is not a confirmed fit by Thule, but it works the exact same way and will give you that extra roof clearance if you need it. It also has a weight capacity of 165 lbs.

expert reply by: Evangeline M

0

Answer 1

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 2

I have included a image below showing one of the Thule roof racks installed on a Jeep Wrangler having the Sky One-Touch roof. They used the Crossbars #TH711520 with the 8" Tall Feet #TH33ZR. I could not find any images with the roof open but you…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Compatible Roof Rack for 2021 Jeep Rubicon With Sky One Touch Soft Top?

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching