Extra Long Hitch Pin for Toyota Tacoma Factory Hitch

Question

Question:

Would that fit a an Yakima King Pin? The original bolt is too short for my Tacoma receiver...

asked by: Thiago

0

Expert Reply:

The # Y8890200 hitch pin will fit the Yakima KingPin, but it still won't be long enough to pass through your wider that usual factory receiver on your Toyota Tacoma.

You'll need to remove the threaded insert in the shank of your bike rack, and at that point you'll be able to use an extra long lockable hitch pin like # 34061072-D which is compatible with the receiver on your Tacoma. Because the pin isn't threaded, you'll lose the anti-wobble feature but it would secure the rack in your hitch and help deter theft.

expert reply by: Mike L

0

Answer 1

Sounds like you are looking for everything needed to install electric trailer brakes on a trailer that did not originally come with electric brakes. I attached a link to an FAQ to the right that will walk you through the entire process. As far as…

view full answer...

Answer 2

Hey Eric. Sorry but there is no other hitch pin that is compatible with the threads on the Kuat Hi-Lo Hitch Extender - 2" Hitches - 7" or 10" Extension item #HL20B. We keep running into these issues with the Toyota receivers and the…

view full answer...

Answer 3

The bolt that comes with the #Y8890185 is the same as the #Y8890176. The bolt is a 1/2"-13 bolt that is 4.28" long with 2.5" of threads.

view full answer...

Answer 4

Thanks for the pictures John! I reached out to Yakima and they are aware of the double wall receiver on the new Toyota's but do not have a solution for it as of (09/12/2024). The only solution I have for you today is to drill out the threads on…

view full answer...

Answer 5

Hey Ezra, for the Yakima Long Haul Bike Rack part #Y02476 the correct replacement hitch pin bolt would be the part #Y8890200. Did you lose yours?

view full answer...

Answer 6

The Yakima Replacement Hitch Bolt and Clip for Yakima HoldUp Hitch Mounted Bike Carrier, part #Y8890200, is a 5/8 inch bolt. The size wrench you would use to install or remove this bolt is 15/16 inch.

view full answer...

Answer 7

To ensure you get the correct replacement cross arm for your Yakima HoldUp bike carrier, we will want to know if you have the newer style black model or the older style gray model. If you have the older gray model, then you will want either the Front…

view full answer...

Answer 8

The Replacement Hitch Bolt #Y8890200 is the correct bolt for your Yakima HoldUp Bike Rack #Y02443. We also have the Replacement Hitch Hardware #8890260 if you need to replace the insert inside the Spine #8890277.

view full answer...

Answer 9

I believe you are referring to the Yakima HoldUp #Y02443. If you need just the HitchLock alone, that is the #Y07235. However, if you need the hitch pin that is compatible with both the HitchLock and the HoldUp itself, that is the #Y8890200.

view full answer...

Answer 10

We have actually seen this issue before. The 2" receivers on Toyota trucks and SUVs have a slightly larger diameter on the outside of the receiver tube than most typical 2 inch hitches. This is partially the powder coating, but the steel itself…

view full answer...

Answer 11

Since most bike carrier manufacturers use proprietary threads for their bike carrier like the Doubledown, the dimensions are not freely acquired. We have the replacement hardware, part #Y8890176 you can use to secure the bike carrier to the trailer…

view full answer...