InfiniteRule Hitch Lock for 2-1/2" Hitches - 3-1/8" Span - Stainless Steel

Video Transcript for Review of InfiniteRule Hitch Locks - Standard Pin Lock - 34061072-D

Today we're going to take a look at the InfiniteRule stainless steel hitch lock for the two and a half inch hitches. And this has a 3 1/8 inch fan. Now this is a flush style hitch lock which will secure your ball mount or your accessory to your 2 1/2 hitch. This also can be used to secure the Gen Y 10,000 pounds or 16,000 pound ball platform to a ball mount. It is also compatible with the late model Toyota Tundras and Tacomas that have a two inch factory hitch that has an outside width have more than 2 5/8 inches. This will work for that application.

This lock is a heavy duty stainless steel construction. You can see on the head portion it has the grooves in there, makes it very easy to grab.On the inside, once I demonstrate this and take the head off, I'll show you, on the inside there is an O-ring which will protect the internal components from any dirt and grime. You can see it has this nice weather resistant tethered dust cap, helps keep the water and debris out of the key ways and it does come with the two keys. Just to unlock it, put your key in there and then you just twist it like you're unscrewing a bolt. That'll allow you to remove the head from the lock.

Once you get it turned enough, the head will come right off and then near you can see as that O-ring I mentioned that'll protect the internal components. This part is made in the USA. And then when you go to install this and then you just put this on the other side once it's installed. To put the head back on you just twist it, tighten it down. Once you get it tight, just tighten it up and then back it off a little bit, pull your key out, put your cap on and it's locked all ready to go.

Simple as that.Again, the application on this is for 2 1/2 inch by 2 1/2 inch trailer hitch receivers. Now this lock does have a sheer strength of 42,000 pounds. And basically the sheer strength is determined by placing this locking pin in a stress position and they subject it to increasing force until a required proof load is met or the pin fails. Again, this lock has a sheer strength of 42,000 pounds. Pin diameter on this is 5/8 of an inch.

And a few overall dimensions on this, the overall length from one end to the other, it's right at 5 3/4 inches. And we had mentioned the span length, which is the inside portion right here is 3 1/8 inches.But again, just to show you, put your key in and then just loosen it, unscrew it and the head will come off and then you're ready to install it. And once you install it, just go ahead and twist it back down to tighten it. And once you get it installed, pull your key out, put your cap on and you're all ready to go. But that should do it for the review on the InfiniteRule stainless steel hitch lock for the 2 1/2 inch hitches.