Repair Kit for the Titan 2-5/16 Inch Weld-On Coupler # T1755000

Question

Question:

I have an older trailer that the coupler locking mechanism is broke. Can I buy just the moving parts of that coupler? The piece of flat half rounded steel that moves around the ball has fallen off , but every thing else is still there.

asked by: Rich M

0

Expert Reply:

If the coupler on your trailer is the Titan 2-5/16 Inch Weld-On Coupler, # T1755000, then you can use the Titan Coupler Repair Kit, # T1848700. This kit includes all necessary components to replace the broken wedge on your coupler.

expert reply by: John H

0

Answer 1

To check the pins on the vehicle side 7-Way, you can use a circuit tester or the volt meter. The circuit tester will show you if a signal is coming through on the pin you are testing while the volt meter will tell you that and how much voltage is…

view full answer...

Answer 2

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Answer 6

Hey Kenny, welcome back! The reason for that note is because all of the new systems since 2025 use R32 refrigerant due to EPA regulations. Any 2024 and older systems use R410A and their parts are not compatible with the R32 units. It doesn't mean…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

No, it does not James. The etrailer Electric Trailer Jack item #e22QV includes a 7-way connector and snap pad but not cover. The plastic housing will keep water from getting inside and damaging the controls. All of the buttons are covered in a…

view full answer...

Answer 9

Tyler, great question - and it’s definitely more than cosmetic. The etrailer electric trailer jacks #e72QV and #e22QV are mechanically identical 3,500 lb jacks. Same motor, same lift height of 18", same 7-way plug power. The only difference is…

view full answer...

Answer 10

The Kodiak Disc Brake Kit #K2HR10A11RERR is actually specifically designed to fit an AL-KO 10k #99 spindle, so this will be a perfect replacement. Though this does include the oil cap, it should be noted that it does not include the bearings or seal.…

view full answer...

Answer 11

Hey Matt. You can indeed power a electric tongue jack off of your tow vehicle's 7-way connector since you don't have a battery. I recommend the etrailer Electric Trailer Jack w/ 7-Way item #e74GV. This jack has a 5,000 lbs capacity and…

view full answer...

Answer 12

Hey Mark! All three of these etrailer jacks - the #e72QV 3,500 lb, the #e22QV 3,500 lb with SnapPad, and the #e82QV 5,000 lb with SnapPad - are powered directly through your truck’s 7-way plug. So with your Silverado’s factory 7-way, you can simply…

view full answer...

Repair Kit for the Titan 2-5/16 Inch Weld-On Coupler # T1755000

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching