See what our Experts say about this Ultra-Fab Products Camper Jacks

• Troubleshooting Ultra-Fab Phoenix Electric Tongue Jack That Won't Extend or Retract
  The Ultra-Fab Phoenix Electric Trailer Jack with Remote- 5,500 lbs # UF38-944055 or 4,000 lb # UF38-944040 without remote sounds like it may have a mechanical issue. I recommend using the manual crank to extend or lower the jack. If you can use this, then you isolate the issue to electrical with a possible bad ground or motor issue. If you can't physically move the jack with the manual crank then we know the issue is mechanical with the inner rod seized or having stripped threads. If...
  view full answer...
• Troubleshooting Bulldog Powered Drive Trailer Jack Switch Working Intermittently
  Hi William; thank you for being a loyal, long time customer! There are a few things you can check on your Bulldog Powered Drive Trailer Jack # BD500200. The first thing I would do is check the ground and make sure it is still secure. It could be your ground connection is loose and manually cranking the jack is moving the wire enough for good contact allowing the switch to work. After that, I would check for power. If you aren't getting full 12V power it could be the batteries are wearing...
  view full answer...
• Powered A-Frame Jack Recommendation for A-Frame Bumper Horse Trailer
  Hey Alison, so I really like the Phoenix trailer jack part # UF38-944055 as it's the fastest working jack out there that can raise and lower your trailer nose in a matter of seconds and is super reliable.
  view full answer...
• Phoenix Electric Trailer Jack Compatibility With A Big Toe BE-5 12K Bobcat Trailer
  Thank you for the pictures. Since you have an A-Frame you will be able to use the Phoenix Electric Trailer Jack with Remote # UF38-944055. If you don't have a battery or plan on installing one then you'll want to wire the jack to the 12 volt accessory wire on your 7-way cable to power the jack whenever you're hooked up to the truck.
  view full answer...
  
• Amp Draw Of The Ultra-Fab Phoenix Electric Trailer Jack
  The Phoenix Electric Trailer Jack with Remote # UF38-944055 can pull 5 amps with no load or 12-15 amps with a load. This jack does come with a 240v 30 amp slow blow fuse and fuse holder so that you'll be ready to go when you get it.
  view full answer...
  
• Determining The Correct Electric Tongue Jack For A Big Toe BE-5 12K Bobcat Trailer
  Tongue weight is going to typically be 10-15% of the trailer's GWVR, so at 12,000lbs you'd be looking at roughly 1,200-1,800lbs maximum tongue weight (when properly loaded). If the trailer is an A-Frame bumper pull then the Phoenix Electric Trailer Jack # UF38-944055 you were looking at would be a compatible fit. It has a 5,500lb capacity and is one of the fastest jacks currently on the market. If it's not an A-Frame send me some pictures and I'd be happy to take a look and figure out what...
  view full answer...
• Troubleshooting A Phoenix A-Frame Trailer Jack That Does Not Operate Anymore
  There is still some troubleshooting you can do, however if the troubleshooting does not solve the issue you're going to either have to reach out to Phoenix for a replacement jack or pick out your own. With that being said, the first thing you can check is your ground connection. Often times this is over looked because it feels too simple to check or people just forget but you'd be surprised how often a bad ground ends up being the culprit. If your ground looks good, then I'd move onto...
  view full answer...
• Mounting Bolt Pattern For Ultra-Fab Phoenix Electric Trailer Jack with Remote # UF38-944055
  The Phoenix Electric Trailer Jack with Remote # UF38-944055 has a multiple mount hole pattern. This pattern allows you to position the jack so the motor faces the front of the A-Frame, or it can be rotated so that the motor faces the drivers side of the camper. I have included an image of the mounting pattern so that you will be able to confirm fitment on your 2014 Arctic Fox 25R travel trailer. It is designed to fit standard A-Frame jack holes that accept 2-1/4" tongue jacks.
  view full answer...
  
• Electric Trailer Jack Recommendation for 2022 Shamrock Flagstaff 19
  Hey Gary, if you wanted a powered a-frame jack that works great and also doesn't break the bank we have the etrailer jack part # e55ZV. Now if you were looking for something really nice that raises and lowers in a matter of seconds the Phoenix jack part # UF38-944055 would be what you would need.
  view full answer...
• Best Electric Trailer Jack for a 2016 2016 Dutchmen Coleman Light Travel Trailer M-2305QB
  I'd be more than happy to help you find an electric jack for your 2016 Dutchmen Coleman Light M-2305QB Travel Trailer! If you're looking for best of the best then look no further than the Phoenix Electric Trailer Jack # UF38-944055. What sets this jack apart from the rest is the fast operation (extends 6" in 18.4 seconds), it includes a remote control, and it comes with a 10-year warranty if you register it within 90 days. This will hardwire into the electric on your trailer battery bank. For...
  view full answer...
• What is Electric Fastest A-Frame Trailer Jack
  The fastest powered a-frame jack we offer is the Phoenix Jack part # UF38-944055 that you referenced which can travel 10 inches in just 47 seconds. Depending on where you would mount the battery would determine if you'd need a battery box.
  view full answer...
• Is There A Trailer Jack For A 2021 Coachman Spirit XTR Available That Has An Auto Stop Feature?
  I took a look at the Stromberg Carlson Electric Trailer Jack # SC63VR and the Bulldog Powered Drive Trailer Jack # BD500199 I believe I have found a comparable solution. I know this is not exactly what you're looking for, however none of our A-frame jacks have an auto-stop function like you're looking for, but I did find the: - Phoenix Electric Trailer Jack with Remote # UF38-944055. This jack has a maximum weight capacity of 5,500lbs, 26" of travel, and will extend 6" with a 1,000lb...
  view full answer...
• Recommendation for a Powered A-Frame Trailer Jack
  For a Bulldog A-frame trailer jack like # BD155032, or a similar jack, there is not an electric conversion available. For a powered A-frame jack, the highest capacity we carry is a 5,500 pound model # UF38-944055. Since it will be at the front of the trailer, all of the trailer weight will not be on it, just the tongue weight of the trailer. Provided the tongue weight of your trailer does not exceed 5,000 pounds, this jack will work. I have incldued a link to an FAQ article that shows...
  view full answer...
• Phoenix Electric Trailer Jack Memory Storage and Calibration Hole For UF38-944055
  The Phoenix Electric Trailer Jack with Remote # UF38-944055 will retain its memory when the battery on your travel trailer is disconnected in storage. I have added an image of the calibration hole that is to line up with edge of the outer tube when you have to recalibrate the jack after having to move it manually.
  view full answer...
  
• Troubleshooting the 5,500 lbs. Ultra-Fab Phoenix Electric Tongue Jack That Won't Retract
  If you can use the emergency override that allows for manual operation of your Ultra-Fab Phoenix Electric Trailer Jack, # UF38-944055, then that minimizes the mechanical failure possibilities and isolates the issue to electrical components. I suggest you ensure there is a full charge on your battery as low voltage will have an effect on operation. If you have a full charge I suggest you focus on the electrical connections and the switch. If you cannot retract using the manual operation,...
  view full answer...
• Warranty of Phoenix Electric Trailer Jack With Remote
  The Phoenix Electric Trailer Jack with Remote - A-Frame - 26" Lift - 5,500 lbs # UF38-944055 has a 2-year warranty. I have added a link to a video review of this jack for you to take a look at.
  view full answer...
• Trailer Jack Recommendations for a 10,000 Pound A-Frame Trailer
  A trailer jack only lifts part of the weight of the trailer and not the whole 10,000 pounds of your trailer. A 10K trailer would have a tongue weight of around 1,000 to 1,500 pounds. But the higher the capacity of the jack the easier it is for the jack to lift the weight and the longer it will last. A jack rated for 5,000 pounds such as # TJA-5000S-B is an option. You could add foot # JF-99 as well. I have linked a video review of the jack for you. If you'd prefer an electric jack then...
  view full answer...
• Height Above Trailer Frame Phoenix Electric Trailer Jack
  From the bottom of the mounting surface of the Phoenix Trailer Jack part # UF38-944055 to the very top of the jack measures 27 inches.
  view full answer...
  
• Recommended A-Frame Electric Jack for 2022 Forest River No Boundaries 19.6 Travel Trailer
  For a jack with a higher capacity for your 2022 Forest River No Boundaries 19.6 Travel Trailer I recommend the Phoenix Electric Trailer Jack with Remote - A-Frame - 26" Lift - 5,500 lbs # UF38-944055. This has the capacity you're looking for at 5,500 lbs and has a total lift of 26". This jack also extends and retracts 6" in approximately 18 seconds with 1,000 lbs of tongue weight. If you have any issues with the jack down the road Ultra-Fab Products will get you taken care of. You can...
  view full answer...
• Fast Lifting Powered A-Frame Trailer Jack
  That's a really clever idea for a jack for your v-nose trailer. You could use the Phoenix Electric Jack part # UF38-944055 which has a remote that you can use to raise and lower it from the outside of the trailer. This is also one of the fastest moving powered jacks out there as well.
  view full answer...
• Electric Trailer Jack With Dead Battery on Trailer
  No, your Phoenix Electric Trailer Jack with Remote # UF38-944055 is not able to operate while connected to your truck if the trailer battery is dead, since drawing power from the truck battery via the 7 way connector will most likely overload the jack and blow a fuse. The electric jack should only rely on the trailer battery to be operated. In order to operate your electric trailer jack, you'll need to connect the trailer to the vehicle or connect the battery to an external charging source...
  view full answer...
• How To Get More Height From A Stromberg Carlson Tongue Jack
  To get more height from your 2019 Grand Design Reflection you will need to use trailer jack blocks like # SC88VR, I did also speak to Stromberg Carlson to confirm this information. You could alternatively use a different jack to achieve more height. We offer these jacks that are guaranteed to fit your 2019 Grand Design Reflection Travel Trailer 315RLTS: The Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 23" # JET-5000 would give you an extra 1/2" The Phoenix Electric...
  view full answer...
• Trailer Jack Just Clicks and Will Not Raise Trailer
  The first thing I recommend checking on the jack is the power source. If the battery that runs the jack is low on power then it will be hard for the jack to lift the trailer (lowering it tends not to be a problem because gravity is helping) and it may just refuse to do anything. If the voltage on the battery is good and the wiring is all intact then it is possible that the jack had been over extended at some point and the screw and/or nit inside is damaged. This would mean that a replacement...
  view full answer...
• Can Electric Trailer Jack be Used To Assist With Weight Distribution Hitch Spring Bar Installation
  It sounds like you want to use a trailer jack like the Phoenix Electric Trailer Jack with Remote # UF38-944055 to assist with the spring bar installation on your Blue Ox weight distribution hitch. Assuming you are using the jack to lift your trailer for installation that is fine. It can "assist" in picking up the rear of the truck by raising the trailer and removing the weight from the truck. It cannot, however, be installed on the truck and used to physically lift the rear of the truck. I...
  view full answer...