Are There Instructions for Installing the Replacement Heating Pad for Thomas Payne Recliner

Question

Question:

How do you replace the heating pad in a Thomas Payne recliner in an RV?

asked by: George Z

0

Expert Reply:

Lippert, who make the Thomas Payne line of furniture, does not offer specific instructions for installing the Replacement Heater Pad # 674864 that you referenced. Installing this heating pad requires more or less disassembling the couch cushions to access the pad, unplugging and removing the old heater and reversing the process to install everything.

If you also need the plug, that is available with part # 195-000113.

expert reply by: Erik B

0

Answer 1

You will have to go from the side or underneath. Then you can unplug and remove the old pad and replace it with the Replacement 29-Volt Seat Heating Pad for Thomas Payne Seismic Series RV Couches and Chairs #674864. If you need to replace the entire…

view full answer...

Answer 2

Thomas Payne does not offer specific instructions for installing the Replacement Heater Pad #674864 that you referenced but it's more or less disassembling the couch cushions to access the pad, unplugging and remove the old heater and reversing…

view full answer...

Answer 3

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 4

The best replacement we have for your Innoflame RV48D80L-1 fireplace is the Furrion Electric RV Fireplace with Crystals #FF40SW15ABL. This fireplace is a bit smaller, measuring 39-7/16" wide x 17-3/4" tall x 6-1/4" deep, has 4…

view full answer...

Answer 5

Hi Katrina! Good question. It's so good that I actually went out to our warehouse to check the specs printed on the 12V Cord #195-387595 and then did some math on top of that! The Replacement Cord is going to draw between 150 and 360 watts, while…

view full answer...

Answer 6

We do carry a couple of replacement control boxes like the Replacement Power Control Box for Thomas Payne Seismic Recliners and Sofas #LC36FR which will work with the Seismic series recliner and sofas, and the Replacement Control Box for Thomas Payne…

view full answer...

Answer 7

Thanks for your question, Kim! We do have exactly what you need for your Carson trailer. Based on your measurements, it looks like you have the standard-size entry door window. If you’d prefer a black frame, you’ll want to go with part #37211021.…

view full answer...

Answer 8

You will want to look at the legs of your steps to determine which MORryde steps you have. If your MORryde steps have a pull pin then you've got the 1st generation. If you have a button that releases the legs for adjustment, you have the second…

view full answer...

Answer 9

The recliners run off of 110V AC, using a standard 110V outlet. So, if your camper doesn't already have a power inverter you could use one like the Go Power #34280176. If your loveseat is a Thomas Payne model, you can use the #195-387595…

view full answer...

Answer 10

I wasn't able to find anything with that part number, but if you have a Seismic series sofa, then you'd want the Replacement Power Cord with Power Supply Box for Thomas Payne Seismic RV Power Reclining Sofas #195-000111, but if you have a…

view full answer...

Are There Instructions for Installing the Replacement Heating Pad for Thomas Payne Recliner

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching