Are There Instructions for Installing Replacement Heater Pad # 674864

Question

Question:

Is there a step by step to replace the heating pad

asked by: Jeff B

0

Expert Reply:

Thomas Payne does not offer specific instructions for installing the Replacement Heater Pad # 674864 that you referenced but it's more or less disassembling the couch cushions to access the pad, unplugging and remove the old heater and reversing the process to install everything.

expert reply by: Jameson C

0

Answer 1

You will have to go from the side or underneath. Then you can unplug and remove the old pad and replace it with the Replacement 29-Volt Seat Heating Pad for Thomas Payne Seismic Series RV Couches and Chairs #674864. If you need to replace the entire…

view full answer...

Answer 2

Lippert, who make the Thomas Payne line of furniture, does not offer specific instructions for installing the Replacement Heater Pad #674864 that you referenced. Installing this heating pad requires more or less disassembling the couch cushions to…

view full answer...

Answer 3

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 4

Thanks for that info; since you have the power recline on your Thomas Payne recliner, the correct replacement heating pad is the following: - Replacement 29-Volt Seat Heating Pad for Thomas Payne Seismic Series RV Couches and Chairs #674864

view full answer...

Answer 5

You can get a replacement heating element for your Thomas Payne sofa, with the right one depending on if your sofa has the power recline function or not. - Without Power Recline Function: Replacement 12 Volt Seat Heating Pad for Thomas Payne RV…

view full answer...

Answer 6

We do have some replacement heating pads for your Thomas Payne recliner's. Depending on what series you have, we may have a solution for you. If you have the Thomas Payne Theater seating, #LC38UD will work for you. If you have the Seismic Series…

view full answer...

Answer 7

Hey Greg, I would recommend you go with the part #K23-472-473-00 which is the exact correct size and capacity your trailer needs. If you go with a wider assembly (if it would fit) you don't really gain better braking performance and instead you…

view full answer...

Answer 8

That is correct you will just need to replace the damaged heating pads with the Replacement 12 Volt Seat Heating Pad #LC38UD since you have the manual reclining seats. According to Lippert's manual the removal process is the same for fabric and…

view full answer...

Answer 9

Sorry for the delay, I wasn't getting any word back from Seaflo until today. Their rep recommends checking your Accumulator Tank #SE38FR quarterly. Seaflo's Accumulator tanks have a small air bag inside of them that can lose pressure over…

view full answer...

Answer 10

I spoke with my contact at Lippert who said that either the heater is bad or the control box needs to be replaced on your Thomas Payne Momentum recliner. To test the heater unplug the red and black wires from the control box (located behind and under…

view full answer...

Are There Instructions for Installing Replacement Heater Pad # 674864

Product Page this Question was Asked From

Continue Researching