Do You Have a Tandem Axle Suspension Kit with 5.75" x 2" Equalizers

Question

Question:

Do you have this kit with a 5.75inch wide by 2inch tall equalizer?

asked by: Craig

0

Expert Reply:

Yes the Suspension Kit for Tandem-Axle Trailers part # AP233 has the 5.75" x 2" equalizers you are looking for included.

Check out the video I linked on it for you.

expert reply by: Randy B

0

Answer 1

Spring #e84SR being slightly off from the existing hanger spacing you have now would require welding on new hangers on a single axle trailer. The end of the spring that uses the shackle strap and is not secured to the hanger alone should be slightly…

view full answer...

Answer 2

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Answer 3

The easiest way to determine the correct replacement parts for your trailer's suspension is by simply measuring its existing components. Looking at one of your current equalizers, you will want to measure from the center of the front hole to the…

view full answer...

Answer 4

To find the proper replacement equalizer for your horse trailer you will need to take a couple of measurements. Measure from the center of the front hole to the center of the rear hole. Then measure from the center of the top hole down to the center…

view full answer...

Answer 5

The Dexter 8-222 model hubs currently on your trailer are designed primarily for mobile home use, and these types of hubs typically use unique bearing combinations that make it really difficult to find full replacement assemblies. Mobile home parts…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Do You Have a Tandem Axle Suspension Kit with 5.75" x 2" Equalizers

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching