Can CE Smith Bunk Brackets CE10196G-4 Be Used with 7k Boat
Updated 08/13/2020 | Published 08/12/2020
Question:
I’m rebuilding the bunker brackets on my Pacific Trailer to accommodate a 1998 Grady White 228-g boat that totally gassed up and equipment weighs around 7.000 pounds. Trailer is built out of 5” C-channels with 12 bunker upright supports used to mount 2 2’x6’x810’ long bunker boards and 2-6’ long B-Boards. Will the Smith brackets hold this much weight? I also need a drawing showing the over all dimensions of the brackets With the bunker board angle bracket attached so I can determine what length to buy with out having them stick down pass the c-channel support.
asked by: Ralph C
Expert Reply:
The CE Smith Brackets # CE10196G-4 you mentioned do not have a stated weight capacity but as long as you install them properly and use your best judgement with placement and with the bunks you'll be fine with what you are doing.
Here's dimension info on the brackets:
Dimensions of bolster bracket: 15" tall x 4" wide
Mounting slot dimensions: 3" long x 1/2" wide
Horizontal spacing between slots: 1-3/4"
Dimensions of swivel bracket: 3-1/2" long x 1-1/2" wide x 2" tall
Flange mounting hole diameters: 3/8"
Flange mounting hole spacing: 2-1/2" apart on center
1-1/4" Between each of the 3 holes
Product Page this Question was Asked From
CE Smith Double U-Bolt Bolster and Swivel Bracket Assemblies - Galvanized - 16-1/4" - Qty 4
- Boat Trailer Parts
- Bunks
- Swivel Bracket
- U-Bolt Bunk Bracket
- 15 Inch Tall
- 2 Inch Tall
- 1-1/2 Inch Wide
- 4 Inch Wide
- Galvanized Steel
- 3-1/2 Inch Long
- CE Smith
more information >
Continue Researching
- Search Results: brake line
- Search Results: trailer bunk
- Search Results: 185/80r13
- Video: Detailed Breakdown of the Kodiak Disc Brake Assembly
- Shop: CE Smith Double U-Bolt Bolster and Swivel Bracket Assemblies - Galvanized - 16-1/4" - Qty 4
- Shop: Karrier ST185/80R13 Radial Trailer Tire - Load Range D
- Shop: Loadstar ST185/80D13 Bias Trailer Tire with 13" Galvanized Wheel - 5 on 4-1/2 - Load Range D
- Shop: Kodiak Hydraulic Brake Line Kit - Single Axle - 18'
- Shop: Kodiak Disc Brake Assembly - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Shop: Kodiak Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Shop: Kodiak Hydraulic Brake Line Kit - Tandem Axle - 20'
- Video: Breaking Down the CE Smith Double U-Bolt Bolster and Swivel Bracket Assemblies
- Video: CE Smith Double U-Bolt Bolster and Swivel Bracket Assemblies Review
- Q&A: Replacement Rollers For Wobble Rollers To Eliminate Marks and Gauging In The Boat Hull
- Video: Comprehensive Review: Stainless Steel Hex Lag Screw
- Q&A: What Is The Recommended Bunk Board Length For 16' Long Boat?
- Q&A: Replacement Bunk Brackets for Older Grady White Seafarer Boat Trailer
- Video: Review of the CE Smith Heavy Duty Swivel Bracket
- Video: All About the CE Smith Carpeted Bunk Boards for Boat Trailers
- Video: An In-Depth Look at the CE Smith Swivel Bracket for Boat Trailers
- Search Results: 2338
- Search Results: fulton trailer jack
- Q&A: Recommended U-Bolts for Bracket Replacement on Boat Trailer With 3x3 Frame
- Search Results: wesbar
- Search Results: wesbar 271595
- Shop: Performance Chip Tuners
- Q&A: Do You Have a Complete Wobble Roller Bunk Assembly?
- Q&A: Can Demco Surge Actuator Install on Trailer Tongue with Different Bolt Pattern
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Replacement Winch for Non-Serviceableet Pre-2007 Fulton T1200 Winch
on Boat Trailer Parts
