Compatibility of Boat Trailer Roller Bunks with CE Smith Swivel Bracket Assemblies # CE10196G-4

Question

Question:

will this bracket fit my Dutton Lainson roller bunks? I need a long bracket and do not think Dutton Lainson makes them this long.

asked by: Bob T

0

Expert Reply:

If your Dutton Lainson roller bunks have a flat bottom surface like part # DL21741 then you can mount them directly to the CE Smith Bolster and Swivel Bracket Assemblies # CE10196G-4 as shown in the linked photo. These are the tallest ones we offer. If the bunks have an open channel in the bottom, like part # DL21755, then you will want to first mount the bunks to a 2 x 4 bunk board which will fit into that channel and then mount that to the brackets.

expert reply by: Adam R

0

click to enlarge

Answer 1

This trailer was either set up this way by the manufacturer or the owners had to fabricate some extensions and then attach brackets and the stops to make this set up. Extensions would have to be fabricated by a machine shop or a welder and then you…

view full answer...

Answer 2

The diameter of the mounting bolt hole on the CE Smith Bow Roller Bracket for Winch Stands, #CE31005PG, is .45 inch. The bracket uses a 5-1/4 inches long x 1/2 inch diameter steel shaft for attaching the roller/Y-stop, which is part #CE10700A.

view full answer...

Answer 3

I am not familiar with the exact bow stop you have pictured but we do carry a few options such as the Yates Flat Bow Stop for Boat Trailers part #YRJONBLOCK which is what I recommend using. It's designed to be used with a bracket such as the CE…

view full answer...

Answer 4

The best part about boat trailers is that everything is universal so a lot of the parts you add to them are about preference and have to do with the type of boat you're carrying. I recommend checking out the CE Smith Bow Roller Assembly with…

view full answer...

Answer 5

The closest bow roller bracket for winch stands that we have to the dimensions you listed is the CE Smith #CE31005PG. This bracket is 13-3/16" tall and is designed to fit around a 3-1/2" wide winch. We do not currently offer any brackets…

view full answer...

Answer 6

We don't carry the Knot Autoflex couplers, but we do have a solution that could work for you. You could assemble a solution of parts we offer that would consist of: • JIF Marine 2500 lb 2-speed hand winch, part #315-W2500D • Winch Stand, part…

view full answer...

Answer 7

You can use roller bunks like the #DL21741 on your trailer. They can be attached to wood bunks like what you have too. Without seeing your trailer it's hard to say what the best route would be, but people use roller bunks on pontoon boat trailers…

view full answer...

Answer 8

EZ Loader doesn't list a specific bow stop for any of the trailers so you will need to measure to find the right fit. You need the shaft diameter and width of your bracket. For example, if you have a 1/2" shaft and the bracket fits a 3"…

view full answer...

Answer 9

We have a variety of bow stops like you referenced and I've linked the page to all your options. Unfortunately the small base and hole size you asked about are not a direct fit as that is not a common size. My recommendation is to go with the CE…

view full answer...

Answer 10

You could use a bracket such as #CE31005PG for bow stop #YRJONBLOCK. A lot of trailers use this type of bracket for bow stops. I have also included a link to all of the brackets we carry.

view full answer...

Compatibility of Boat Trailer Roller Bunks with CE Smith Swivel Bracket Assemblies # CE10196G-4

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching