Size of Bolts for Brophy D-Ring Tie-Down Anchor

Question

Question:

what are the size of the anchor bolts that fasten the unit to the bed of the trailer? it does not show the size of the holes in the drawing, are they 7/16? i am assuming that the bolts are 3/8 diameter. Thnx

asked by: Ron G

0

Expert Reply:

The bolt that comes with the Brophy D-Ring Tie-Down Anchor with Backing Plate # DR1S has a diameter of 9/16 inches, so this would be the approximate size of the hole in the backing plate as well.

I have added a link to a video review for you to check out of the Tie-Down Anchor with Backing Plate # DR1S.

expert reply by: Kyle S

0

Answer 1

The Brophy D-Ring Tie-Down Anchor #DR1S actually comes with it's own backing plate. The black portion of it mounts under the surface and then using the included hardware you'd attach the D-ring on top of the surface. I attached a review video…

view full answer...

Answer 2

Hey Jordan! Yes, the Global Link Vise Lock #295-000024, Global Link RV Entry Door Locking Latch #295-000019, and Replacement Cam Lock Cylinder #295-000005 can all use the same key. Just make sure you choose the keyed alike option for each one before…

view full answer...

Answer 3

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 4

Hi Wayne, I went out to the warehouse and measured the Caliber D-Ring Anchor Kit part #CA89VT for you. The plate dimensions are 4" long by 3 3/4" wide and the inner diameter of the ring is 1 1/4" and outer diameter is 2 1/4". What…

view full answer...

Answer 5

The easiest way to tell the difference between the 2007 Chevy Silverado Classic and New Body Style is the tail gate or the tail lights. The new body style will have a large Chevy bow tie emblem in the center of the tail gate. It will also have red…

view full answer...

Answer 6

The mounting brackets of the Buyers Products 5/8" Forged D-Ring With 4-Hole Integral Mounting Bracket #337B40MP that you referenced are 6 inch by 1 inch. I would recommend using these on the other side of your truck bed when attaching these to a…

view full answer...

Answer 7

Hi Stephen; the thread on the removeable eye bolt is 3/8". The #348819 anchor/shank is 5/8".

view full answer...

Answer 8

Yes, you can use the factory trailer connector on your 2015 Nissan Titan to power the third brake light on your Leer camper shell. That said, they don't make a plug and play harness for this so you will need to do some wiring but no splicing into…

view full answer...

Answer 9

Hello Ben, Thanks for writing in! Yes! The WeatherTech Front Auto Floor Mats #WT54TZ you were looking at are made specifically for the factory vinyl floor in your 2026 Ram 2500. For the rear, WeatherTech does not have a matching custom-fit rear mat…

view full answer...

Size of Bolts for Brophy D-Ring Tie-Down Anchor

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching